- Home
- Domestic appliances
- Large home appliances
- Water heaters & boilers
- Vaillant
- ecoMAX
- Installation manual
advertisement
834177_13GB_042005.qxd 09.03.2005 17:57 Uhr Seite 29
Boiler installation sequence 4
4.16.4 Connection details for programmable thermostats
ACL Drayton
Lyfestyle PT271, PT371
ACL Drayton
Digistat 2, 3, 4
ACL Drayton
Digistat RF - SCR Receiver
Danfoss Randall
TP4, TP5, TP5E
Danfoss Randall
TP5E RF with receiver RX1
Danfoss Randall
TP75
Grässlin Towerchron
RTC7
Honeywell
CM61, CM67, CM31, CM37
Horstmann
Centaurstat 1, 7
Landis & Staefa
REV 11, REV 15, REV 22
Smiths Timeguard
ProgramaSTAT PRT11, PRT17
Sunvic
TLX 6501
Sunvic
TLX RFP, TLX RFD
Vaillant
VRT 230, 220
L N 1
L
1
N
2
3
3
2 3 4
4
3
L N 1
4
2 3
L
3
N 3
2 1
4
4
L N 1
3
2 3 4
L
A
N
B C 1
3 4
2 3 4 5 6
3 4
1 2 3
3
A B
4
C
3
1
4
2 3
3
L
4
L1
4
3
L
4
N 3 4
L
1
N
2
3
3
4
3 4
L N 1
L
3
N
4 5
2 3 4
3 4
3 4 5
Fig. 4.20
4.17 Controls (ecoMAX 800)
4.17.1 External electrical controls
The boiler terminals 3, 4 and 5 are for connecting external electrical controls such as a time switch and/or room thermostat. Terminals 3 and 4 are linked together when the boiler is supplied. If external controls are used, this link must be removed, and the controls connected across terminals 3 and 4. Terminal 5 is an additional neutral connection for external neutrals such as from the anticipator of a room thermostat.
4.17.2 Connection of external controls
4.17.3 Connection details for programmable room thermostats
Fig. 4.19 shows the connection details where a programmable room thermostat (time switch with built in room thermostat) is used to control the boiler.
Important:
The arrowed numbers indicate connection into the relevant terminal in the boiler terminal strip.
Instructions for installation and servicing ecoMAX
advertisement
Related manuals
advertisement
Table of contents
- 20 Pressure Relief Valve (ecoMAX 600)
- 20 Pressure Relief Valve (ecoMAX 800)
- 29 thermostats
- 29 Controls (ecoMAX 800)
- 29 4.17.1 External electrical controls
- 29 4.17.2 Connection of external controls
- 29 thermostats
- 30 4.17.4 Connection details for time switch
- 34 Commissioning part I
- 34 Preliminary electrical checks
- 34 Gas supply
- 34 Cold water supply (ecoMAX 800)
- 34 (ecoMAX 800)
- 34 Initial system flush (”Cold”)
- 34 (ecoMAX 600)
- 34 Initial system flush (”Cold”)
- 34 Filling condensate trap
- 38 Refitting the case
- 38 (range rating)
- 39 Functional checks
- 39 Procedure
- 40 Hot–water supply (ecoMAX 800)
- 40 Heating system
- 40 Final system flush (”Hot”)
- 40 Handing over to the user
- 42 7.2.2 Inspect main heat exchanger
- 42 7.2.3 Inspect burner
- 43 7.2.4 Refitting the compact thermal module
- 43 7.2.5 Cleaning the condensate trap
- 43 7.2.6 Check expansion vessel
- 44 Recommissioning the boiler
- 44 Troubleshooting
- 44 Logical fault finding procedure
- 44 Status mode
- 46 Diagnosis mode
- 48 Fault codes
- 48 8.1.4 Fault memory
- 50 Test programs
- 52 Replacement of gas valve
- 52 expansion vessel
- 54 (air–ratio adjustment)
- 55 Recycling and eventual scrapping
- 55 The appliance
- 55 Packing