Test. Zenmuse H3-2D

locked and you have to contact our customer support.

Test

STEP1. Check List Before Every Flight

For safety reasons, please pay serious attention to all following items Before Every Flight.

(1) Gimbal is installed firmly to aircraft, and camera mounted correctly and stably. Make sure the Lens of camera is pointing to the aircraft nose direction.

(2) All cables are in correct and firm connection, without anyone in backwards.

(3) Gimbal video signal cable is in good soldered condition if wireless video transmission module used.

Make sure to connect Wireless Video Transmission Unit to GCU first, then power on.

(4) Correct TX settings.

(5) Correct camera settings.

(6) Normal connection between GCU and autopilot system.

(7) Upgrade Autopilot System MC Firmware.

STEP2. Test

1.

2. Switch on the TX.

Make sure the batteries are fully charged for transmitter, GCU and all the other devices on your aircraft.

3. Power on gimbal and wait for self-testing.

4. After initializing, camera lens will point to aircraft nose direction, that is, the three axes of gimbal should be in the condition as the above diagram shows.

5. Toggle the Tilt Control switch on your transmitter, and make sure it is working properly. Then try to feel if your gimbal moves to the corresponding direction. If not, check your settings.

Note:

 If the gimbal is abnormal (unlike the diagram shows) after initializing, turn to Trouble Shooting in

Appendix.

©2013 DJI Innovations. All Rights Reserved.

14