advertisement
5. Remove the two door closer inserts (Figure 37) from the existing bottom hinge and install as shown on the new bottom hinge (Figure 36).
6. Remove existing bottom hinge (three screws) and remount on opposite side TOP. Remove hinge screw pin.
7. Remove the plastic hole plug from the top of the door to allow the pivot pin to be inserted in the new location. Install the plug into the vacated hole on the opposite side.
To install the door shelf:
1. Holding shelf in center, align notches in shelf with bosses in door (Figure 39).
2. Tilt shelf at a 15°-20° angle and slide onto bosses at the desired location.
Glass Shelf Removal/Installation
2
1
ULIN_0006_A
Figure 38
8. With bottom of door facing up, remove pivot plate
(two screws), flip over, and remount on opposite side of door (Figure 38). Be sure notch in plate faces
center.
9. Holding door upright with top of door tilted forward, place hole of door pivot plate on bottom hinge screw pin/closer inserts (Figure 36).
10. Tilt top of door into position in top hinge and install top hinge screw pin.
11. Install metal hinge plugs removed in Step 2 in old hinge holes (three each, top and bottom).
Door Shelf Removal/Insertion
Notch
Boss
ULIN_0276_A
Figure 40
1. Pull shelf out about 6" (Figure 40) until back of shelf clears the "hump" on the right-hand side.
2. Tilt right-hand edge of shelf up. Remove shelf from unit by pulling out (Figure 40).
Insert the shelves as follows:
1. To move to a different position in the unit, insert shelf at an angle, approximately 15°-20°, over the rib in the side of the unit where you want to place the shelf. The shelf must be started into the unit at an angle to clear the door.
2. Continue to slide the shelf into the unit at an angle until it clears the door.
3. Lower the shelf and push it in completely.
Light Bulb Replacement - Model
CLRCO2175 Only
To replace the light bulb in your U-Line unit:
ULIN_0039_A
Figure 39
To remove the door shelf:
1. Grasp shelf in center, lift slightly, and tilt 15°-20°.
2. Carefully pull shelf off bosses (Figure 39).
Lens
Tab
Figure 41
ULIN_0001_A
CLR2160, CLRCO2175 19
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 4 1-Safety Precautions
- 4 Safety Alert Definitions
- 4 General Precautions
- 5 2-Product Features
- 5 3-Service
- 5 Before Calling for Service
- 5 If Service is Required
- 5 4-Replacement Parts
- 6 5-Installation
- 6 Prepare Plumbing
- 6 Water Supply Connection
- 7 Drain Connection
- 10 Final Water/Drain Connection
- 11 6-Electrical Specifications
- 11 7-Initial Startup
- 12 8-Operation
- 12 Turn Unit On/Off
- 12 Temperature Digital Display
- 12 - Model CLRCO2175 Only
- 13 9-Normal Operating Sounds
- 13 10-Outdoor Usage
- 13 11-Storage, Vacation or Moving
- 14 12-Product Disposal
- 14 13-Maintenance and Cleaning
- 14 Exterior Cleaning (As Required)
- 14 Defrosting
- 15 Condenser Cleaning
- 16 Clear Ice Maker Cleaning
- 17 Ice Cube Thickness Adjustment
- 18 Leveling
- 19 Door Alignment Check and Adjustment
- 20 Door Reversal - Black and White Models Only
- 21 Door Shelf Removal/Insertion
- 21 Glass Shelf Removal/Installation
- 21 Light Bulb Replacement - Model CLRCO2175 Only
- 22 14-Troubleshooting Guide
- 24 15-Electronic Control Quick Guide