Quidway S9300 Terabit Routing Switch
Configuration Guide - IP Routing
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 BGP4+ Configuration
Context
Do as follows on the BGP4+ router:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bgp as-number
The BGP view is displayed.
Step 3 Run:
ipv6-family [ unicast ]
The BGP IPv6 unicast address family view is displayed.
Step 4 Run:
peer { ipv4-address | ipv6-address | group-name } reflect-client
The route reflector and its clients are configured.
The switch on which this command is run serves as the route reflector. In addition, this command specifies the peers that serve as its clients.
----End
9.11.3 (Optional) Disabling a Route Reflection Between Clients
If the clients of a route reflector are fully meshed, you can disable route reflection between clients to reduce the cost.
Context
Do as follows on the BGP4+ router:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bgp as-number
The BGP view is displayed.
Step 3 Run:
ipv6-family unicast
The BGP IPv6 unicast address family view is displayed.
Step 4 Run:
undo reflect between-clients
Issue 01 (2011-10-26) 660
