Verifying configuration using Dashboard. Cyberoam FIREWALL

How To – Deploy Cyberoam in Gateway mode

Note:

After changing the LAN IP address, you must use this IP address to reconnect to the web admin console. You might also have to change the IP address of the management station to be on the same subnet as the new IP address.

This finishes the basic configuration of Cyberoam and now you are ready to use the

Appliance.

Verifying configuration using Dashboard

Browse to https:\\192.168.01 and log on to Web Admin Console using default username and password. Dashboard page is displayed on successful log on.

1. Verify appliance information

Check the Appliance Information section of Dashboard to verify configuration.

2. Verify gateway status

Check the Gateway Status of Dashboard and verify that the status of the gateway green i.e.

UP.

How To – Deploy Cyberoam in Gateway mode

3. Verify IP assignments

Go to System> Network Configure > Manage Interface page and check IP address assigned to Interfaces. If you have not configured IP scheme properly, you can run the Network

Configuration wizard and change the IP address.

4. Verify DNS status

Browse to http://<Cyberoam IP address>/dg.html and log on with default username and password and verify that DNS status is “Ok”.