advertisement
4. Adjust the media guide to the size of the media stack.
Multipurpose Feeder Tip
Occasionally, in a Macintosh OS 9 environment if media is in the multipurpose feeder, the system’s Print Monitor sends a prompt message to put paper into the manual feed tray and click OK.
This prompt can only be turned off in Print Monitor. You cannot turn the manual feed message off on the Desktop Print Monitor.
1. Go to System Folder: Extensions: Print Monitor.
2. Double click Print Monitor to open it. Then, select File: Preferences.
3. Select Give no Notifi cation under When a manual feed job starts; then, click OK.
Connecting the Power Cord
Plug the platemaker into a dedicated, properly grounded AC outlet. Do not use an extension cord. Use a surge protected outlet to help prevent power source fl uctuations from damaging your platemaker.
1. Make sure the platemaker’s power switch is off (the O is pressed in).
2. Connect the power cable’s female connector to the back of the platemaker and the male connector to a standard electrical outlet.
Never use a damaged power cord. Check the cord and plug monthly and replace immediately if you fi nd any damage.
18 PlateMaker 6 User’s Guide
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Key Features
- High-resolution laser scanner for sharp, detailed images
- Durable construction for long-lasting performance
- Variety of software features for easy use and customization
- Generates a small amount of ozone gas during image transfer in the printing process
- Invisible laser beam inside the platemaker’s scanner unit can cause permanent eye damage
Related manuals
Frequently Answers and Questions
What is the power consumption of the PlateMaker 6?
What type of power cord is required for the PlateMaker 6?
What are the FCC regulations for the PlateMaker 6?
advertisement