Technika Manual

Gas Conversion (NG to U-LPG)

If the required gas conversion kit is not supplied with your appliance, contact Technika. Gas Conversion shall only be undertaken by authorised persons.

The NG to U-LPG conversion kit contains...

- Test Point Assembly - ULPG Gas Type label

- Auxiliary Jet Ø0.53mm

- Rapid Jet Ø0.90mm

- Semi-Rapid Jet Ø0.70mm

- Wok Jet Ø1.00mm

Converting to a different gas type

When converting from Natural Gas to Universal LPG ensure that the

NG regulator is removed and replaced with the Test Point Assembly supplied in this kit. An AGA Approved gas regulator suitable for a supply pressure of 2.75kPa should be part of the gas tank supply and the test point pressure must be adjusted to 2.75kPa.

Changing the jets

1. Remove pan supports, burner heads and caps.

2. Use a size 7 socket wrench to unscrew and remove the jets, replacing them with those supplied in this kit. Ensure you use the correct jet for the corresponding burner.

3. Reassemble the burner heads, caps and pan supports.

4. Fit the Gas type label supplied with this kit next to the gas connection point and remove the existing label.

Setting the minimum level

1. Light one of the burners and turn the tap to minimum flame.

2. Remove the corresponding control knob.

3. Use a thin blade screwdriver to turn the by-pass screw located in the brass shaft as shown right.

Turn the by-pass screw fully clockwise. The result should be a small, stable flame which is uniform around the entire burner ring. If not, turn the by-pass screw anti-clockwise until satisfied with the flame.

4. Check that the burner does not go out when the tap is turned quickly from the maximum to the minimum position.

5. Repeat for each burner.

16