Positioning Oven Feet. Jenn-Air JMW2430DP, JMW3430DS, JMW2427DB, JMW2430DB, JMW3430DB

3. At a 45° angle, align the door hinges with the slots in the lower front of the oven cavity. Slowly insert the door, making sure you maintain the 45° angle. You will know the door is engaged in the slot when you feel a slight drop.

Positioning Oven Feet

The oven feet need to be installed to allow a microwave/oven combination to be installed in a recommended cutout height of

42

1

⁄

2

" (107.9 cm).

NOTE: Do not remove the spacers.

4. Lower the oven door to the fully open position. If the oven door does not open to a full 90°, repeat steps 1 through 3.

5. Locate the oven door hinge locks in the corners of the oven door, and rotate the hinge locks toward the oven cavity to the locked position.

See Step 3 (illustration A) in the “Remove Oven Door” section for the proper locked position.

A

A. Spacers

1. Using 2 or more people, place the oven on its back on a covered surface.

6. Close the oven door.

7. When the hinges are properly installed and the door is closed, there should be an even gap between the door and the control panel. If one side of the oven door is lower than the other, the hinge on that side is not properly installed.

Repeat the steps to remove and replace the oven door. See

“Remove Oven Door” and “Replace Oven Door.”

5

5