ZFC26500WA User Manual Chest Freezer

Operation

Switching on

A. Temperature Regulator

B. Half Loaded position

C. Full Loaded position

A

B

C

1. Insert the plug into the wall socket.

2. Turn the Temperature Regulator to the Full

Loaded position and let the appliance run for 24 hours to allow the correct temperature to be reached before placing food inside.

3. Adjust the Temperature Regulator according to the quantity of the stored foods.

Switching off

Turn the Temperature regulator to the OFF position.

Temperature regulation

The temperature within the appliance is controlled by the Temperature Regulator situated on the control panel.

Before first use

WARNING!

Refer to Safety chapters.

Cleaning the interior

Before using the appliance for the first time, the interior and all internal accessories should be washed with lukewarm water and some neutral

Daily use

WARNING!

Refer to Safety chapters.

To operate the appliance, proceed as follows:

• to obtain the minimum coldness, turn the

Temperature Regulator toward lower settings.

• to obtain the maximum coldness. turn the

Temperature Regulator toward higher settings.

In case of freezing less food volumes, the Half Loaded setting is the most suitable. In case of freezing much food volumes, the Full Loaded setting is the most suitable.

soap to remove the typical smell of a brand-new product, then dried thoroughly.

CAUTION!

Do not use detergents or abrasive powders, as these will damage the finish.

Freezing fresh food

The freezer compartment is suitable for freezing fresh food and storing frozen and deep-frozen food for a long time.

www.zanussi.com

5