1.5.3 Auto-induction Mode. CILICO CT10X

1.5.3 Auto-induction Mode

Under the Auto-induction Mode. The users just need to move the barcodes to be scanned in front of the light band of CT10X, no need press the Scan Key, there will show a red light line. This indicates the scanner could scan, the scanning will not stop until the scanner under the following situation.

* Read a barcode successfully;

*The pre-set timeout expires (the default time is 2s).

induction Mode

You also can setup the best auto-induction distance according to actual demand, read the following barcode for setup.

Setup Auto-induction Distance

For Example:

1. Read the "Enter Setup" barcode;

2. Read the "Auto-induction Mode" barcode;

3. Read the "Setup Auto-induction Distance";

4. Read the numeric barcode in Appendix I; (0 means farthest, 9 means nearest)

5. Read the "Exit with Save" barcode.

Then enter the Auto-induction Mode.

Enter Setup

Exit with Save

Exit without Save

21