TY96/TY96A Installation Manual

TY96/96A and TY97/97A VHF Radio Installation Manual

01238-00

1.

Preface

22 June 2017

Issue AE

1.1 Purpose

This manual describes the physical and electrical characteristics and the installation requirements for a

TY96 or TY97 VHF and TY96A or TY97A VHF radio.

1.2 Scope

This Manual applies to the installation of the TY96, TY97 and TY96A, TY97A VHF radio.

At the publication date of this manual the software version identifier for the TY96/TY97 is 1.6 and the

FPGA version identifier is 1.1. The software and FPGA versions are subject to change without notice.

1.3 Changes from Previous Issue

Minor spelling and grammar changes

Addition of TY96A and TY97A 25KHz variants.

Changed pin 7 name to ‘Mono Audio Out’

Added brief explanation of L, R audio positioning

Corrected error in section 6.1 that states ‘TC90’ rather than TY96

Added COG (centre of gravity) position to installation drawing

Correction to diagram 5 for BK197A remote transfer interface

Addition of wiring harness connector pin view to wiring drawings

Throughout

Throughout

Section 5.4

Section 5.4.4

Section 6.1

Section 12

Section 12

Section 12

1.4 Document Cross-References

01239-00 TY96 TY96A and TY97 TY97A VHF Radio Operating Manual

ETSO 2C169a VHF Radio communication receiving equipment operating within the radio frequency range 117.875 – 137 MHz

TSO C169a Minimum Operational Performance standards for Airborne Radio

Communications equipment standards

ETSO 2C128 Devices that prevent blocked channels used in two-way radio communications due to unintentional transmissions

TSO C128a Equipment that prevents blocked channels used in two-way radio communications due to unintentional transmissions

AC

EASA

FAA

EASA

FAA

Trig Avionics Limited

______________________

Page 1