advertisement
3.1.2
Opening the battery compartment
The battery compartment may now be opened by un-tightening the screw on the left side. Remove the plastic side cover and insert 12 rechargeable Nickel-Metal-Hydride (NiMH) batteries or eventually alkaline batteries.
NOTE: On the left side of the battery compartment, you will find the hexagonal wrench (2 mm) which enable you to completely disassemble the SX-ST without using any other tool.
WARNING: Never leave discharged batteries in your SX-ST. Make sure that your SX-ST only contains rechargeable NiCd or NiMH batteries before charging. When using dry cells use only professional alkaline batteries to ensure optimal running time. Also check the manufacturing date.
3.1.3
Closing the battery compartment
Replace the plastic side cover and tighten the screw. ( Do not over tighten )
NOTE: Some rechargeable D-Cells are longer than standard dry D-Cell and slight difficulty may be found in closing the compartment if such batteries are used. Your nearest SONOSAX agent or the manufacturer in Switzerland can provide assistance if a problem arise due to this difference in length.
Replace the battery compartment while holding in the slide-locks and make sure the power contacts are correctly positioned. The battery compartment is in place when the slide-locks return easily to their original position.
Mode d’emploi SONOSAX SX-ST / SX-VT Page 10 de 73
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 5 INTRODUCTION
- 5 Safety Instructions
- 6 FIELDS OF APPLICATIONS
- 6 MAIN FEATURES
- 7 Versions, options and accessories
- 7 SONOSAX SX-ST
- 7 SONOSAX SX-VT
- 8 VCA Mic/Line Input: version with Compressor and optional VCA groups
- 8 Stereo Line Input: available with or w/o VCA groups
- 8 Digital Module: Analogue to Digital Converter ( Option )
- 8 Digital Module: 8 track Internal Recorder ( Option )
- 9 POWERING
- 9 Powering from batteries
- 9 Removing the battery compartment
- 10 Opening the battery compartment
- 10 Closing the battery compartment
- 11 Battery Test
- 11 Low Battery alarm [LO BATT]
- 11 Battery charger (option for SX-ST Series only)
- 11 External DC supply ( SX-ST only )
- 11 Automatic changeover of the DC power source
- 13 MIC/LINE INPUT MODULE
- 14 Input selector [ XLR – IN B ]
- 14 Direct channel Output [ LINE OUT ]
- 14 Phantom power [ DYN - 48V ]
- 15 Input GAIN setting [ GAIN ]
- 15 Limiter (non-VCA version)
- 15 Filtrer and Equalizer
- 15 Sweep Low Frequencies Cut [ LF CUT ]
- 16 3 bands semi-parametric Equalizer [ EQ ]
- 17 Mix busses assignments [ 1 to 8 ]
- 17 Panoramic Potentiometer [ PAN ]
- 18 Auxiliary Sends [AUX 1 to 4]
- 18 AUX busses assignment [ PRE–OFF–POST ]
- 18 Channel fader
- 18 Level switch [12 - 24]
- 18 Dual Peak Level Meters
- 19 On / Mute Key [ ON ]
- 19 PFL/AFL Pre-Listening [ P/A ]
- 19 Channel power on switch [PWR –ON])
- 20 VCA groups selector (modules with VCA only)
- 20 Compressor (modules with VCA only)
- 20 Threshold
- 20 Ratio
- 20 On Air Signalling (SX-VT only)
- 20 Fonction MUTE
- 21 STEREO LINE INPUT MODULE
- 22 Left & Right gain controls
- 22 Selector [ MONO ]
- 22 Stereo Equalizer [ EQ ]
- 22 Auxiliary Sends [AUX 1] to [AUX 4]
- 22 Auxiliary routing switches [PRE-OFF-POST]
- 23 Dual Peak level meter
- 23 Assignment to mix busses 1/2 to
- 23 Channel Fader
- 23 Left – Right Balance [ BAL ]
- 24 On / Mute Key [ ON ]
- 24 Fader Start [ REMOTE ]
- 24 PFL/AFL Pre-Listening [ P/A ]
- 25 MASTER AND MONITORING MODULE
- 26 METERING
- 26 Meter's operating mode [ ST-M-Low Batt ]
- 26 Meter's backlight [ BACK ]
- 26 Led's operating mode [ LEDS ]
- 26 Signalling Leds [ ON AIR ] and [ MUTE ] (SX-VT only)
- 27 Talkback/SLATE and Oscillator
- 27 Source Selector [ MIC-OSC-FIX ]
- 27 Pre listening Selector [ PFL-AFL-SOLO ]
- 27 P/A operating mode [ Normal-Reset ]
- 27 Powering ON/OFF
- 28 Return lines 1 to 8 [ RETURN ]
- 28 Return's Master Level
- 28 MONITORING
- 28 Monitor Source Selector
- 28 Monitor Mode selector
- 29 Headphone volume [ PHONE 1 ] to [ PHONE 3 ]
- 29 Communication and Private Lines [ COM – PL1 – PL2 ]
- 29 Comm. Monitor Attenuation
- 29 [ Mic 1 ] to [ Mic 3 ]
- 30 MASTER SECTION
- 30 GROUP Masters
- 30 AUX Masters
- 30 Modulomètre à 5 Leds
- 31 Key [ P/A ]
- 31 Commutateurs [ Talkback-Off-Return ]
- 32 DIGITAL MODULE: A/D CONVERTER & INTERNAL 8 TRACKS RECORDER
- 33 A/D Converter
- 33 Sourcing selector [IN 1 MIX] to [IN 8 MIX]
- 33 Red led indicator [ L/O ]
- 33 Protection Limiter's [ LIMITERS ]
- 33 Sampling frequencies
- 34 Clocking and Sync
- 35 INTERNAL RECORDER
- 35 CONNECTIONS
- 35 Port USB
- 35 Remote Connector [ REMOTE ]
- 35 Time Code Connector [ TC ]
- 35 Sync Connector [ VIDEO IN ]
- 36 PRINCIPLE OF OPERATION
- 36 User Interfaces
- 38 ARCHITECTURE - Audio path
- 39 TRACKS MONITORING
- 39 Monitoring Level
- 40 Solo Monitoring
- 41 MENUS CONTEXTUELS
- 42 MONITORING
- 43 LAST TAKE
- 44 PLAYER Mode
- 45 SEARCH mode
- 46 Contextual menu in mode [PLAYER]
- 46 Unit STATUS
- 48 SETUP (Configuration's Menus)
- 49 Tree structure of the "SETUP" menus
- 50 ROUTING SETTING
- 51 RECORD SETTINGS
- 54 TIME CODE SETTINGS
- 55 MODULOMETERS
- 55 USER SETTINGS
- 56 SYSTEM SETTINGS
- 57 MISC (Miscellaneous)
- 58 BROWSE FILES
- 60 MANAGING THE RECORDER
- 60 Formatting the HardDisk and CompactFlash card
- 60 Fragmentation de l'espace libre du disque dur
- 61 USB 2.0 connection
- 62 Alarmes
- 62 Traitement des erreurs
- 63 Up-date procedure
- 63 Recommendations
- 64 ANNEXES
- 68 SPECIFICATIONS