Replacing bulbs at the rear. Ammann ARX 45 K, ARX 36, ARX 40, ARX 40 K

10.3.2

Replacing bulbs at the rear

At the rear, you have direct access to the work light (1) and the tail lights (2).

1

2

Work light

NOTE

Tail light

10.4

Fig. 10-8 Work light / tail light

3

4

1

2

5

6

Remove the entire work light from the water tank.

Remove the plug from the rear of the lamp unit.

Remove the guard.

Press on the end of the securing clip to remove it.

Replace the defective bulb with a new one of the same type and power.

Put the guard back on the casing.

The guard must sit firmly on the glass body of the low beam headlight unit in order to prevent water from entering.

1

2

Remove the lamp housing.

1.1

To do so, undo the screw in the center of the housing.

Replace the defective bulb with a new one of the same type and power.

Gas strut

Gas struts are maintenance-free! They require no maintenance such as lubrication.

They are designed for the respective requirements and work trouble-free for many years.

122 ARX 4