operating manual

®

RS34 - RS48 - RS59

Troubleshooting

The machine does not work.

Water does not flow at the blade while the pump is running.

Motor is not running properly.

Pump is not running.

Bad cutting alignment.

- The power supply cable is damaged or not properly connected.

- No voltage in the power outlet.

- Start Switch is damaged.

- The sprayers are clogged.

- The water level in the waterbin is not sufficient. The pump is not totally submerged.

- Water valve is closed.

- Water may have seeped through inside the motor.

- Capacitor is damaged.

- Motor bearing are damaged.

- Press the plug firmly in the power outlet. Check the power supply cable.

- Have the power outlet checked.

- Have the Switch replaced.

- Clean the sprayers

- Fill the waterbin with clean water until the pump is totally submerged.

- Open the valve.

- The impeller or suction filter of the pump is damaged.

- No proper connection of the power cable.

- Replace damaged parts.

- Have the connection checked.

- Machine is not level.

- Unlevel working surface.

- Improper or glazed diamond blade.

- Unplug the power cable and consult your local dealer.

- Unplug the power cable and consult your local dealer.

- Unplug the power cable and consult your local dealer.

- Loosen the screws for the legs.

Pick up the machine a little bit on one end. Let the machine down again and tighten screws. Do the same procedure for the other end.

Machine should now be level.

- Make sure the machine is placed on a level surface.

- Replace or dress the diamond blade.

Page 13

BEAST BRIDGE SAWS OPERATING MANUAL