IMPORTANT SAFETY INSTRUCTIONS. SolarEdge HD-Wave Inverter
The SolarEdge HD-Wave Inverter enables you to capture maximum power from your solar panels. It features independent MPPT at the module level, ensuring efficient energy production. The inverter also transmits data to the SolarEdge Monitoring Portal, allowing you to track your system's performance.
Advertisement
Advertisement
Advertisement
Key features
Independent MPPT at the module level
Efficient power conversion
Data transmission to monitoring portal
Safe DC technology
User-friendly interface
Easy installation and commissioning
Frequently asked questions
To activate the inverter, insert the activation card into the slot marked 'CARD' on the communication board, turn the AC ON, and follow the instructions on the LCD screen.
Refer to the power optimizer datasheets for the minimum and maximum string length guidelines. The SolarEdge Site Designer can also help verify string length.
Connect the AC wires to the AC terminal block according to the labels on the block. Ensure all wires are fully inserted and cannot be pulled out easily.
Press and hold the inverter LCD OK button for 10 seconds until 'Pairing Turn Switch On' appears. Then turn the inverter ON/OFF switch to ON within 5 seconds.
The inverter enters Standby mode until its working voltage is reached. This mode is indicated by the flickering green inverter LED. The inverter monitors the grid and verifies correct voltage and frequency during this time.