warning. NXP CodeWarrior Development Studio

Chapter 31 Pragmas for Diagnostic Messages

/* Compiler does not warn that b is unused. */

}

This pragma does not correspond to any CodeWarrior IDE panel setting.

31.9 warning

Controls which warning numbers are displayed during compiling.

Syntax

#pragma warning on | off | reset (

num [, ...])

This alternate syntax is allowed but ignored (message numbers do not match):

#pragma warning

(

warning_type :

warning_num_list [,

warning_type :

warning_num_list , ...])

Parameters

num

The number of the warning message to show or suppress.

warning_type

Specifies one of the following settings:

• default

• disable

• enable

warning_num_list

The warning_num_list is a list of warning numbers separated by spaces.

Remarks

Use the pragma showmessagenumber

to display warning messages with their warning numbers.

This pragma only applies to CodeWarrior front-end warnings. Using the pragma for the back-end warnings returns invalid message number warning.

CodeWarrior Development Studio for Advanced Packet Processing Build Tools Reference Manual, Rev.

10.2, 01/2016

Freescale Semiconductor, Inc.

485