Multi-function charger “V-charge 50”

c) Loading battery data

• Select the function „BATT MEMORY“ in the main menu of the charger with the button „INC“ or „DEC“.

• Confirm the selection by pressing the „START/ENTER“ button. The memory number flashes.

• Select one of the 10 memories with the buttons „INC“ or „DEC“.

PROGRAM SELECT

BATT MEMORY

[ BATT MEMORY 1]

LiPo 7.4V(2S)

If there are data in the memory, the display will show in the bottom line alternately, e.g., the rechargeable battery type and the cell number, as well as the charging and discharging current.

When the memory is empty, the bottom line shows only the information „ENTER SET ->“.

• Load the battery data from the selected memory by pushing the button

„START/ENTER“ for 3 seconds.

The display shows the message „ENTER CHARGE LOAD.....“; the data are then loaded and the desired charging/discharging programme can then be started (push the button „START/ENTER“ again for 3 seconds).

[ BATT MEMORY 2]

ENTER SET->

ENTER CHARGE

LOAD...

If you keep the button „START/ENTER“ pushed for 3 seconds in an empty memory, the charger will start selection/setting mode, see chapter 14. a).

36