advertisement
Chapter 7: Microsoft Cluster Disaster Recovery (Windows NT 4.0)
4. Replace the cluster shared disks.
5. Check the drive assignments through Windows Explorer. The “phantom” drives you see are the original shared disks. These drives cannot be deleted or disconnected from the Windows Explorer.
6. Remove the Registry entries for the phantom disks: a. Use regedit to display the following Registry entry:
HKEY_LOCATION_MACHINE\SYSTEM\CurrentControlSet\Services
\ Clusdisk\Parameters\Signatures
The numbers listed under Signatures are the drive signatures for the former shared disks. Delete these numbers.
b. Reboot the node.
c. Using Windows Explorer, check the status of the disks. There should no longer be any phantom disks and the new shared disks should have the proper drive letter assignments.
The new shared disk signatures are located in the following Registry key:
HKEY_LOCATION_MACHINE\SYSTEM\CurrentControlSet\Services
\Clusdisk\Parameters\AvailableDisks
Task 6: Recover the Data
To recover the data:
1. Use the NetWorker User program to recover the remaining data from tape.
Do not recover the following:
• System state
• RepairDisk
• Windows NT system directory
For more information, see "Chapter 4: Windows Disaster Recovery" on page 49 .
2. Reboot Node_A.
3. Log in to a domain with Administrator privileges.
7
NetWorker V7.3
Disaster Recovery Guide
135
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 11 Preface
- 11 Audience
- 11 Organization
- 12 Related Documentation
- 13 Conventions Used in This Guide
- 14 Where to Get Help
- 14 Technical Support
- 14 Customer Service
- 14 Customer Feedback
- 15 Chapter 1: Introduction
- 15 Supported Operating Systems
- 16 Definition of a Disaster
- 17 Chapter 2: Preparing for a Disaster
- 17 Backing Up Data
- 18 Gathering the Key Information
- 18 Hardware Information
- 19 Software Information
- 21 Chapter 3: UNIX Disaster Recovery
- 22 Disaster Recovery Procedures
- 23 Replacing a Hard Drive
- 23 Prerequisites
- 23 Replacing the Hard Drive
- 24 Completing the Recovery Process
- 24 Reinstalling and Configuring the UNIX Operating System
- 24 Prerequisites
- 25 How to Reinstall and Configure the UNIX Operating System
- 28 Completing the Recovery Process
- 28 Recovering a NetWorker Server
- 28 Prerequisites
- 29 How to Recover a NetWorker Server
- 38 Recovering a NetWorker Storage Node
- 39 Prerequisites
- 39 How to Recover a NetWorker Storage Node
- 42 Recovering a NetWorker Client
- 42 Prerequisites
- 43 How to Recover a NetWorker Client
- 45 Recovering the NetWorker Management Console Server
- 46 How to Recover the Console Server Database in a Standalone Environment
- 47 How to Recover the Console Server Database in a Cluster Environment
- 49 Chapter 4: Windows Disaster Recovery
- 50 Disaster Recovery Summary of Procedures
- 50 Summary of a NetWorker Server Recovery
- 53 Summary of a NetWorker Client or Storage Node Recovery
- 54 Disaster Recovery of Multiple Computers
- 54 Disaster Recovery of Clustered Computers
- 55 Replacing a Hard Drive
- 55 Performing a Windows ASR Recovery
- 56 Limitations of the Operating System’s Recovery CD-ROM
- 57 ASR Recovery Requirements
- 57 Task 1: Perform an ASR Recovery of the NetWorker Client Computer
- 59 Task 2: Recover Components that Require Special Handling
- 60 Task 3: Verify the NetWorker Client Recovery
- 61 Repairing a Windows NT 4.0 Operating System Installation
- 61 Windows NT 4.0 Recovery Requirements
- 61 Creating an ERD from the REPAIRDISK Save Set
- 63 How to Use the ERD to Repair the Windows NT 4.0 Installation
- 64 Recovering a Windows Installation
- 65 Windows Recovery Requirements
- 66 How to Recover the Windows Operating System
- 71 Recovering a NetWorker Server
- 71 NetWorker Server Recovery Requirements
- 71 How to Recover a Windows NetWorker Server
- 87 Recovering a NetWorker Client or Storage Node
- 88 Partial Recovery of a NetWorker Storage Node
- 88 Task 1: Satisfy the NetWorker Client or Storage Node Recovery Requirements
- 89 Task 2: Reinstall the NetWorker Client or Storage Node Software
- 89 Task 3: Recover the NetWorker Client or Storage Node Data
- 92 Task 4: Verify the NetWorker Client or Storage Node Recovery
- 93 Recovery of DHCP and WINS Databases
- 94 How to Recover a DHCP Database
- 94 How to Recover a WINS Database
- 94 Recovering the NetWorker Management Console Server
- 95 How to Recover the NetWorker Management Console Server Database
- 97 Chapter 5: Mac OS X Disaster Recovery
- 97 Recovering a NetWorker Client
- 97 Prerequisites
- 98 How to Recover a NetWorker Client
- 101 Chapter 6: NetWare Disaster Recovery
- 101 Replacing a Hard Drive
- 102 Obtain the Hard Drive Information
- 102 Replace the Hard Drive
- 103 Completing the Recovery Process
- 103 Recovering the NetWare Operating System
- 102 Prerequisites
- 103 How to Recover the NetWare Operating System
- 105 Completing the Recovery Process
- 106 Recovering a NetWare NetWorker Server
- 106 Prerequisites
- 106 How to Recover a NetWare NetWorker Server
- 113 Recovering a Replicated NDS Partition
- 114 How to Recover a NetWare 4.10 SYS Volume
- 117 SYS Volume
- 122 Chapter 7: Microsoft Cluster Disaster Recovery (Windows NT 4.0)
- 122 Recovering One Node in a Cluster
- 123 Task 1: Evict Node_B from the Cluster
- 123 Task 2: Reinstall Windows NT 4.0 and MSCS on Node_B
- 124 Task 3: Reinstall the NetWorker Software
- 124 Task 4: Recover the Data on Node_B
- 124 Recovering a Cluster Shared Disk
- 125 Task 1: Take the Dependent Resources Offline
- 125 Task 2: Replace the Hard Drive
- 126 Task 3: Recover the Data to the Shared Disk
- 126 Task 4: Configure the Cluster to Include the Shared Disk
- 127 Replacing the Quorum Disk and Recovering Its Data
- 127 About the Quorum Resource
- 128 How to Replace the Quorum Disk and Recover Its Data
- 128 Recovering the MSCS Cluster Configuration
- 129 Task 1: Recover the System State and Quorum Data
- 129 Task 2: Replace the Quorum Data with the Recovered Quorum Data
- 130 Task 3: Evict Node_B from the Cluster
- 130 Task 4: Reinstall the Cluster Software and Patches on Node_B
- 130 Performing a Cluster-Wide Recovery
- 132 Task 1: Reinstall and Configure the Software on Node_A
- 133 Task 2: Reinstall and Configure the Software on Node_B
- 133 Task 3: Reinstall and Configure NetWorker
- 134 Task 4: Perform a Disaster Recovery
- 134 Task 5: Check and Reassign the Drive Assignments
- 135 Task 6: Recover the Data
- 136 Task 7: Check the Disk Signatures
- 137 Task 8: Join Node_B to the Cluster
- 139 (Windows 2000 and 2003)
- 139 Prerequisites
- 140 Recovering a Failed Quorum Disk
- 140 How to Recover a Failed Quorum Disk
- 141 Recovering One Cluster Node
- 142 How to Recover One Cluster Node
- 144 Recovering Multiple Cluster Nodes
- 144 How to Recover Multiple Cluster Nodes
- 147 Troubleshooting Cluster Database Recovery
- 147 Cluster Recovery Environment Variable Settings
- 149 Chapter 9: VERITAS Cluster Server Disaster Recovery
- 149 Prerequisites
- 150 Recovering a Single Cluster Node
- 150 How to Recover a Single Cluster Node
- 151 Recovering an Entire Cluster
- 151 How to Recover an Entire Cluster
- 155 Chapter 10: Sun Cluster Disaster Recovery
- 155 Prerequisites
- 155 Recovering a Single Cluster Node
- 156 How to Recover a Single Cluster Node
- 156 Recovering an Entire Cluster
- 156 How to Recover an Entire Cluster
- 159 Chapter 11: HP TruCluster Disaster Recovery
- 159 Prerequisites
- 159 Record Information
- 160 Back Up the Cluster
- 160 Recovering One or More Nodes in a Cluster
- 161 How to Recover One or More Nodes in a Cluster
- 163 Recovering an Entire Cluster
- 163 How to Recover an Entire Cluster
- 175 Chapter 12: HP-UX Cluster Disaster Recovery
- 175 Recovering a Single Cluster Node
- 175 How to Recover a Single Cluster Node
- 176 Performing a Cluster-Wide Recovery
- 176 How to Perform a Cluster-Wide Recovery
- 179 and Solaris Disaster Recovery
- 179 Recovering a Single Cluster Node
- 179 How to Recover a Single Cluster Node
- 181 Performing a Cluster-Wide Recovery
- 181 How to Perform a Cluster-Wide Recovery
- 186 Renaming the Resource Directory
- 189 Prerequisites
- 189 Recovering a Single Cluster Node
- 191 Chapter 15: HACMP for AIX Disaster Recovery
- 191 Recovering a Single Node
- 192 How to Recover a Single Node
- 192 Recovering an Entire Cluster
- 192 How to Perform a Cluster-Wide Recovery
- 197 Glossary
- 217 Index