Tools Needed. RIDGID R4512

TOOLS NEEDED

The following tools (not included or drawn to scale) are needed for assembly and alignment:

FRAMING SQUARE

PHILLIPS

SCREWDRIVER

FLAT BLADE

SCREWDRIVER

COMBINATION

SQUARE

SOCKET WRENCH

(8 mm, 13 mm SOCKET)

WRENCH

4 mm, 8 mm, 10 mm,

13 mm, 14 mm

C-CLAMP

Fig. 7

14

LOOSE PARTS

The following items are included with the table saw:

A

B

C

N

G

E, F

Q

D

K

O

P

L

K

M

S

L

J

H I

R

Fig. 8

A. Blade Guard .............................................................. 1

B. Anti-Kickback Pawls ................................................. 1

C. Miter Gauge ............................................................... 1

D. Rip Fence .................................................................. 1

E. Height Adjusting Handwheel, Washer, and Knob ..... 1

F. Bevel Adjusting Handwheel, Washer, and Knob ....... 1

G. Push Stick ................................................................. 1

H. Blade Wrench, open end ........................................... 1

I. Blade Wrench, closed end ........................................ 1

J. Hex Keys (3 mm, 4 mm, 5 mm,

6 mm, 8 mm) ............................................................. 1

K. Rear Rail .................................................................... 2

L. Front Rail ................................................................... 2

15

M. Rail Connector Bar .................................................... 3

N. Table Extensions ....................................................... 2

O. Spreader Bar ............................................................. 1

P. Dust Chute ................................................................ 1

Q. Throat Plate ............................................................... 1

R. Front End Cap (left and right) .................................... 2

S. Back End Cap (left and right) .................................... 2

Not shown:

T. Fastener Pack - Large

(contents noted on pack) .......................................... 1

S. Fastener Pack - Small

(contents noted on pack) .......................................... 1

LOOSE PARTS

C

A

H

F

E

B

D

G

A. Leg Stand Side Sections ........................................... 2

B. Leg Stand Front and Back ......................................... 2

C. Outer Corners ............................................................ 4

D. Caster Assembly........................................................ 4

E. Center Support .......................................................... 1

I

Fig. 9

F. Rear Axle ................................................................... 1

G. Front Axle .................................................................. 1

H. Rip Fence Storage Brackets ...................................... 2

I. Foot ........................................................................... 4

16