Hercules User Reference Guide - The Hercules System/370, ESA

7.21 CMDTGT (Specify the command target)

7.21.1 Function

The CMDTGT command specifies the target environment for all following commands entered on the command line of the Hercules hardware console.

7.21.2 Syntax

Descriptive

CMDTGT {HERC | SCP | PSCP | ?}

Diagram

Êʬ¬¬ CMDTGT ¬¬¬§¬¬¬ HERC ¬¬¬§¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬ÊÍ

ª¬¬¬ SCP ¬¬¬¬«

ª¬¬¬ PSCP ¬¬¬«

¬¬¬¬ ? ¬¬¬¬¬¯

7.21.3 Parameter

HERC

SCP

PSCP

?

The command target is the Hercules Emulator. This is the default, when no CMDTGT target has been given.

The target for the commands is the system control program (i.e. the guest operating system running under Hercules).

All entered commands are system control program (i.e. guest operating system) priority commands.

Display the current target environment for commands.

7.21.4 Examples

Example 1:

Display the current target environment for commands.

2008/08/30 09:10:04.390 00000FC4 cmdtgt ?

2008/08/30 09:10:04.390 00000FC4 cmdtgt: Commands are sent to Hercules

Figure 41: CMDTGT command (display current setting)

Hercules Emulator V3.09 – User Reference Guide Page 203

Example 2:

Set the system control program as the target for commands.

2008/08/30 09:10:04.390 00000FC4 cmdtgt scp

2008/08/30 09:10:04.390 00000FC4 cmdtgt: Commands are sent to scp

Figure 42: CMDTGT command (set target to SCP)

Example 3:

Set the command target from SCP or PSCP back to Hercules (see also HERC command).

2008/08/30 09:10:04.390 00000FC4 herc cmdtgt herc

2008/08/30 09:10:04.390 00000FC4 cmdtgt: Commands are sent to Hercules

Figure 43: CMDTGT command (set target back to Hercules)

Hercules Emulator V3.09 – User Reference Guide Page 204