advertisement
▼
Scroll to page 2
of
40
Installation
Rearward-facing installation using seatbelt
1. Start by loosening full length of the top tether
2. Set base in position 3 (High).
3. Swing stabilising arm into position.
PUSH
4. Place restraint facing rearwards on back seat of vehicle in line with a top tether strap anchorage point.
5. Thread the vehicle seat belt through the
BLUE
belt path at the bottom of the restraint and fasten buckle.
SWING UP
6. Press the child restraint firmly down into the vehicle seat and remove belt slack.
7. Attach the top tether strap to the anchorage point. Adjust until all the slack is removed. Ensure Base of seat is not lifted.
PUSH
HIGH
CLICK
NOTE: There is an option to install seat using seat belt with accessory locking clip. Please see instructions provided with locking clip for installation.
WARNING
28
DO NOT LEAVE CHILDREN UNATTENDED IN THE CAR
advertisement
Related manuals
advertisement
Table of contents
- 7 Quick start installation
- 8 Contents
- 9 Introductions
- 12 Warnings
- 14 Correct forward-facing vehicle position
- 15 Anchor fitting location
- 18 Anchor fitting installation
- 19 Angle adjustment
- 21 Parts list
- 24 Configuring harness straps
- 25 Adjust headrest height
- 25 Base adjust
- 26 To fasten buckle assembly
- 27 Adjusting top tether strap
- 28 Rearward-facing installation using seatbelt
- 29 Forward-facing installation using seatbelt
- 31 Rearward-facing installation using ISOGO
- 33 Forward-facing installation using ISOGO
- 34 Next seat for your child
- 35 Cleaning instructions for buckle
- 36 Care instructions
- 36 Removing trim for cleaning
- 37 Removing accessories for cleaning
- 38 Notes
- 39 Guarantee
- 40 Customer service