CARTON INVENTORY
NOT SHOWN: Documentation packet
LA400DC
Pull-to-Open Bracket
Gate Bracket
INTRODUCTION
LA400DCS ONLY
Pull-to-Open Bracket
Standard Control Box with 2 Batteries and hardware bag (watertight connector (4),
30 amp fuse (2), mounting bolt, washer (4), and wire nut (3))
Gate Bracket
Motor Cable
Six Conductor,
40 feet (12.2 m)
Post Bracket
Terminal Block
Junction Box
Connector
Plug-in Transformer
Gate Operator
Gate Operator
(with a 6 foot cable attached)
Post Bracket
Warning Signs (2)
LiftMaster Monitored Retro-Reflective Photoelectric Sensor
HARDWARE INVENTORY
NOTE: Hardware quantities shown below are for LA400DC. Quantities are doubled for LA400DCS.
Flat Washer 5/16" (1) Hex Nut 5/16"-18 (1)
Keylock Cap
Lock Washer 5/16" (1)
Hex Bolt 5/16"-18 x 1-1/2" (1)
Hex Bolt 3/8"-16 x 1-1/2" (1)
Hex Nut 3/8"-16 (3)
Carriage Bolt 3/8" x 5-15/16" (2)
OPTIONAL ACCESSORIES (ORDERED SEPARATELY)
Push-to-Open Bracket (Model 50-19503)
If your application requires the gate to be pushed open, a push-to-open bracket is required (refer to accessories).
Expansion Board (Model K1D8387-1CC)
Large Metal Control Box for Solar Applications
(Model XLSOLARCONTU)
Required for solar installations (batteries not included). Requires two
33AH batteries, battery tray, and solar battery harness (refer to accessories).
5
Key (2)
Pin (2)
Flat Washer 3/8" (3)
Hairpin Clip (2)
Lock Washer 3/8" (3)
