8.6 Change base PIN code. Motorola T203, T104, T202, T204, T201, T101, T102, T103

mode

This setting is useful to access certain network and PABX/switchboard services.

The default recall time is suitable for your country and network operator. It is unlikely that you should need to change this setting unless advised to do so.

1. Press m

, scroll d

to

ADVANCED SET

and press m

.

2. Scroll d

to

RECALL TIME

and press m

.

3. Press u

or d

to select

SHORT

,

MEDIUM

or

LONG

and press m

to confirm.

NOTE

SHORT-100ms, MEDIUM-250ms & LONG-600ms.

mode

Your T2 is set to tone dialling. You should only need to change this if connected to an older type of switchboard / PBX which requires pulse dialling.

1. Press m

, scroll d

to

ADVANCED SET

and press m

.

2. Scroll d

to

DIAL MODE

and press m

.

3. Press u

or d

to select

TONE

or

PULSE

and press m

to confirm.

8.6 Change base PIN code

Some functions are protected by a 4 digit PIN code which must be entered if you want to change the settings. The default PIN is 0000. You can change this to your own preferred number.

When you enter a PIN, the digits are shown as ****.

1. Press m

, scroll d

to

ADVANCED SET

and press m

.

2. Scroll d

to

CHANGE PIN

and press m

.

3. The display shows

NEW -- -- -- --

, enter the new 4 digit PIN code and press m

.

4. The display shows

CONFIRM

. Re-enter the new PIN and press m

to confirm.

IMPORTANT

If you change the PIN code, please keep a record of the new number.

8.7 Registering an additional handset

You can register up to 4 handsets to your T2 base to extend your phone system without having to install extension sockets for each new phone.

If you have purchased a T2 multiple pack, all additional handsets come pre-registered to the base.

If you have purchased an additional handset separately, you must register it to your T2 base before it can be used.

Base settings 27