advertisement
6. Troubleshooting
All ADAM products are designed and manufactured to the highest quality standards.
However, if any problems with your subwoofer occur, we recommend to proceed as follows:
6.1
Problem: The LED shows normal operation (green) but there is either no or only
a distorted audio signal.
Check the volumes of both the subwoofer and your signal source.
Check the wiring. Is the cable defective? Are all cables connected correctly? If possible, check with new cables.
Connect the subwoofer as directly to the signal source as possible (please mind the volume!). Is another part of the signal path (e.g. mixer, audio source) defective?
6.2
Problem: You hear parasitic noises (like humming, buzzing, soughing, cracking).
Please disconnect the signal cables. If the noises disappear, check the signal path.
Make sure that all cables are properly connected, especially the signal cable between the preamp/mixing console/etc. and the sub.
If the noises can still be heard, check for other electrical devices close to the speakers (mobile phones, switching power supplies, etc.). If there is no interfering device the subwoofer will probably cause the problem.
Sub7 Manual / english
11
advertisement
Related manuals
advertisement
Table of contents
- 2 Safety Instructions
- 5 Introduction
- 6 Quick Start
- 6 Important Information
- 6 Quick Start
- 7 Connecting the Subwoofer
- 7 Connections
- 7 Input
- 7 Satellite Out
- 8 Subwoofer Placement
- 8 Distance to satellites
- 8 Walls/Distance to walls
- 8 Finding the optimum position
- 9 Controls on front panel and Remote Control
- 10 Controls on rear panel
- 11 Trouble Shooting
- 11 No or distorted signal
- 11 Parasitic noises
- 12 Maintenance
- 12 Shipping / Packaging
- 12 Environmental Information
- 13 EU Declaration of Conformity
- 14 Limited Warranty
- 14 11.1 Terms and Conditions
- 14 11.2 How to claim
- 15 Technical Data