Merlin commander myq MT110MYQ

To program the travel limits, press the PROG Button until the UP Arrow Button begins to flash. Press and hold the UP Arrow Button until the door is in the desired UP position. Once the door is in the desired UP position press and release the PROG Button. The DOWN Arrow Button will begin to flash. Press and hold the DOWN Arrow Button until the door is in the desired DOWN position. Once the door is in the desired DOWN position press and release the PROG Button. The travel limits and force setting has now been set. Proceed to test safety reverse system.

With the door opened place a 40 mm obstacle laid flat on the floor under the garage door. Operate the door in the down direction. The door must reverse off the obstacle. If the door stops on the obstacle, remove obstacle and repeat Program the Limits and Force Steps, then repeat safety reverse test. When the door reverses off the 40 mm obstacle, remove the obstacle and run the opener through a complete travel cycle. Door must not reverse in closed position. If it does, repeat Program the Limits and Force then repeat safety reverse test.

The MyQ® Gateway System will operate with MERLIN products identified as MyQ® ENABLED. Install the Merlin Garage Door Opener to a fully functional door using the Installation Instructions supplied with the product. Install the Protector System supplied with the MyQ® Gateway kit, using the Installation Instructions supplied with the product. Connect the MyQ® Gateway to your home router using an Ethernet cable. Create a Merlin MyQ® account and register the MyQ® Gateway. You can then add the garage door opener to your account and control it from your smartphone, tablet or computer.