KitchenAid KDRP462L User's Manual

PRODUCT MODEL NUMBERS

KDRP462L

KDRP463L

®

36" Professional Dual Fuel Convection Range

OVERALL DIMENSIONS

*Backguard (required for some installations)

36" (91.4 cm) cooktop width

Gas supply: Use 3/4" (1.9 cm) rigid pipe gas supply line to the range location. A smaller size pipe on longer runs may result in insufficient gas supply. With L.P. gas, piping or tubing size can be

1/2" (1.3 cm) minimum. If local codes permit, it is recommended that new flexible metal tubing, design-certified by CSA, 4-5 feet (122-152.4 cm) long, 5/8-inch (1.6 cm) I.D., be used for connecting the range to the rigid gas supply line. A

1/2" (1.3 cm) male pipe thread is needed for connection to pressure regulator female pipe threads. An individual manual shutoff valve must be located in the same room, but external to the range.

Electrical: A four-wire or three-wire, single phase, 240-volt, 60-Hz, AC only, electrical supply is required on a separate 30-amp circuit, fused on both sides of the line. A time-delay fuse or circuit breaker is recommended.

*9-1/4" (23.5 cm)

1/4" (0.64 cm) spacer

OFF OFF

OFF

OFF OFF

OFF OFF

OFF OFF

OFF OFF

OFF

OFF

45" (114.3 cm) overall height

36" (91.4 cm) cooktop height with feet loosened

3/4 turn

36" (91.4 cm) width

**When installed in a 24" (61 cm) base cabinet with 25" (63.5 cm) countertop, front of oven door protrudes 1 7/8" (4.8 cm) beyond 24" (61 cm) base cabinet.

CABINET OPENING DIMENSIONS

**26-1/2" (67.3 cm) depth with control panel

Cabinet opening dimensions shown are for 25"

(63.5 cm) countertop depth, 24" (61 cm) base cabinet depth and 36" (91.4 cm) countertop height.

13" (33 cm) max. upper cabinet depth 36" (91.4 cm) min. upper cabinet width

For minimum clearance to top of range, see Note.*

18" (45.7 cm) upper cabinet to countertop

*Note: 42" (106.7 cm) min. when bottom of wood or metal cabinet is protected by not less than 1/4"

(0.64 cm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020"

(0.5 mm) copper.

48" (121.9 cm) min. clearance between the top of the cooking platform and the bottom of an unprotected wood or metal cabinet.

36-1/4" (92.1 cm) opening width

28" (71.1 cm)

8"

(20.3 cm) 3-1/2"

(8.9 cm)

4" (10.2 cm) min. clearance from both sides of range to side wall or other combustible material

0" clearance from both sides and back of range to adjacent combustible construction below cooking surface gas line opening to be located in this shaded area

5-1/2" (14 cm)

4" (10.2 cm)

20" (50.8 cm)

12" (30.5 cm) junction box to be located in this shaded area

Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation

Instructions packed with product. Specifications subject to change without notice.

Ref. W10044930 B

01-11-07