Philips AJ260/79 User manual
Add to my manuals
2 Pages
Philips AJ260/79: Wake up to your favorite radio station or a gentle buzzer, and check the weather forecast and indoor temperature as you start your day. Easily set alarms and adjust the time with intuitive controls. Enjoy your favorite radio stations with the auto-scan function and preset buttons. Expand its functionality by connecting a wireless outdoor sensor (sold separately) to monitor the outdoor temperature.
advertisement
Register your product and get support at
www.philips.com/welcome
Clock Radio
AJ260
Quick start guide
AJ260_QSG_79_wk1029.2.indd 1 2010-7-20 13:48:17
Step A
Connect power
1 Connect the supplied mains adapter to the sets 7.5V DC jack and the plug into a wall outlet.
Step B
Set the Clock & Alarm time
1 Press and hold TIME SET or ALM1 /
ALM2 until the time digits flash.
2 Press and hold TUNING +/- to adjust time.
3 Press TIME SET or ALM1 / ALM2 to confirm.
4 Repeat the steps 2-3 to complete all the other time items setting.
Step C
Select the Alarm mode
In standby mode, slide the RADIO/BUZ to select desired mode.
Helpful hints:
– If you have selected RADIO, make sure you have properly tuned to a station before turning off the set.
•
•
Switch off the alarm
•
Press SLEEP/ALARM RESET.
Press REPEAT ALARM/
BRIGHTNESS CONTROL.
Press ALM1 or ALM2.
Listen to radio
1 Press RADIO ON/OFF once to switch on the radio.
2 Press AUTO SCAN/DATE to program all available stations.
3 Press PRESET repeatedly until the desired preset station is displayed.
Weather forecast and Indoor thermometer
The unit can auto detect and measure atmospheric pressure changes to graphically display the weather forecast in the next 12 to
24 hours, and current indoor temperature.
B/3
B
R
C
DC 7.5V
R
A
3
Note:
– The weather forecast based on the atmospheric pressure may vary slightly from the actual weather situation.
Use the outdoor sensor
The outdoor sensor is supplied to work with the main unit to measure and display the outdoor temperature.
1 Place the sensor in a desired open area.
•
•
The place must be within 50 meters away from the main unit. (Make sure that the sensor is loaded with 2 AA batteries.)
For the first time using the outdoor sensor and the main unit, press RESET located on the sensor back, and RESET located in the battery compartment of the main unit. Then, the main unit will begin to receive transmission from the sensor.
To update the outdoor temperature from the sensor any time, press and hold
AUTO SCAN/DATE for 5 seconds.
Note:
– Refer to the supplied User Manual for more information about the outdoor sensor.
© 2010 Koninklijke Philips Electronics N.V.
All rights reserved.
AJ260_79_QSG_V1.0_1029
AJ260_QSG_79_wk1029.2.indd 2 2010-7-20 13:48:17
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Key Features
- Indoor/ outdoor temperature