advertisement
▼
Scroll to page 2
LD 555NL VON DUPRIN. 921028-00 Trim for 5547 concealed vertical rod device Installation instructions , ; , o. , , < Line XX corresponds to line X-X on exit device instructions ——— 2 1. Prepare door for exit device. See exit device instructions for holes, line X P X X-X, and center lines. 1/4” —в р = 1/4” 2. Prepare door for trim: \ y 13/8" dia. Cylinder thru bolt \ | a | a | | cylinder cutout A. Transfer line X-X from inside (exit device side) of door to outside (trim 3/8" side) of door. Use extra care if edge of door is beveled. Be sure | 13/16"— 5 line XX is parallel to edge of door. oo / о | С © ii e B. Locate and prepare all holes as shown. —_ AE A do on cylinder cylinder 3. Apply exit device. Cylinder cam 4. Change handing of trim if necessary (see Figure 1, other side): , Cylinder release 55/16” 4-15/16 bracket A. Dis-assemble trim as shown. B. Position pull grip assembly according to handing of door. C. Re-assemble trim as shown. у у С 5. Install cylinder: Corresponds to A. Cut cylinder tailpiece to length (see Figure 2, other side). exit device | | | center line on B. Install cylinder and assemble component parts (see Figure 1, other side). 10” 10:3/8" exit device 6. Apply trim: instructions A. Install trim thru bolt. B. If hole in trim pull base does not line up with mounting screw, loosen SAT VO! N т \ la \ | | =) & pull base sex bolt extension and revolve base to align. J SL SL | i ae | м 7 3/8” dia. 2 pl C. Install and tighten cylinder thru bolt at top of trim. \ N 3/8” dia. \ \ /8" dia, 2 places \ \ \ D. Tighten thru bolt in bottom pull base Outside face Inside face (see Figure 3, other side). of lock stile Х LHR shown, RHR opposite Х of lock stile Е. Adjust cylinder release bracket to For cutouts on inside face of door, see exit device instructions contact trim cylinder cam. PLIS | Customer Service ve © Allegion 2014 1-877-671-7011 www.allegion.com/us ALLEGION 921028-00 Rev. 01/14-b Standard rim cylinder cover Cylinder и. screws A — Суйпаег dise — and cam NC assembly a Cylinder Cylinder spacer collar Cylinder pull base pull base LHR RHR 3 ) N LS Sex bolt Sex bolt extension extension ¡DD Standard rim cylinder No Socket set screw Socket set cion Y, Cylinder hole Figure 1. To change handing, dis-assemble trim and re-assemble with pull handle in required position. Cylinder hole cover <q—— 23/4" for ——> 2-1/4” thick door —q— 2-1/4” for —— Ja» 1-3/4” thick door Figure 2. Cut cylinder tailpiece to length. \ Loosen this screw | to align pull base E) Use hex stud for 2-1/4” doors OK SU Pull base Figure 3. Tighten thru bolt in pull base. ARR }]УУЗ\А S NN N. +
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement