advertisement
FCC NOTICE
This device has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Connect the computer into an outlet on a circuit different from that to which the receiver is connected.
• Increase the separation between the computer and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment.
FCC Compliance Statement: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
Declaration of Conformity
Compex, Inc. declares the following:
Product Name: Compex 24 Port 10/100Mbps plus 2 Port Gigabit Copper SNMP Managed
Switch
Model No: SGX3226 conforms to the following Product Standards:
This device complies with the Electromagnetic Compatibility Directive (89/336/EEC) issued by the Commission of the European Community.
Electromagnetic Interference (Conduction and Radiation): EN 55022 (CISPR 22)
Electromagnetic Immunity: EN 55024 (IEC61000-4-2,3,4,5,6,8,11)
Power Line Harmonics: EN 61000-3-2 (IEC610000-3-2)
Power Line Flicker: EN 61000-3-3 (IEC610000-3-3)
Product Safety: EN 60950 (IEC60950) ii
Therefore, this product is in conformity with the following regional standards: FCC Class A following the provisions of FCC Part 15 directive; CE Mark following the provisions of the
EC directive.
This Class A digital apparatus complies with Canadian ICES-003. iii
advertisement
Related manuals
advertisement
Table of contents
- 1 Compex Managed Switch Series CGX3224
- 2 © Copyright 2004 Compex Systems Pte Ltd
- 2 Trademark Information
- 2 Disclaimer
- 2 Your Feedback
- 3 FCC NOTICE
- 3 Declaration of Conformity
- 5 Technical Support Information
- 6 About This Document
- 6 How to Use this Document
- 6 Firmware
- 6 Conventions
- 8 Table of Contents
- 11 Chapter 1 Product Overview
- 11 1.1 Introduction
- 11 1.2 Features and Benefits
- 13 1.3 Network Applications
- 16 Chapter 2 Getting Started
- 16 2.1 Packaging Content
- 17 2.2 Setup Considerations
- 17 2.2.1 Software Requirements
- 18 Chapter 3 Hardware Installation
- 18 3.1 Physical Setup for Compex SGX3226
- 18 3.1.1 Desktop Installation
- 18 3.1.2 Rack-Mounted Installation
- 19 3.1.3 Expansion Module Installation
- 19 3.1.4 To remove Expansion Module
- 20 3.2 Connecting Your modem to Compex SGX3226
- 20 3.3 Connecting Your Compex SGX3226 to your Network
- 20 3.4 Performing Power On Self Test (P.O.S.T.)
- 21 Chapter 4 Software Installation
- 21 4.1 Configuring your PC.s setting - TCP/IP Configuration
- 22 4.2 NPfind Utility Software
- 23 4.3 Hyper Terminal Configuration
- 25 4.4 Accessing to web-based Interface
- 25 4.4.1 Login to Web Browser Interface
- 29 Chapter 5 Web-based Interface Configuration for Compex SGX3226
- 29 5.1 Port Configuration
- 31 5.2 VLAN Configuration
- 32 5.3 Trunk Configuration
- 33 5.4 DHCP Config
- 35 5.4.1 DHCP Active Leases
- 35 5.4.2 DHCP Server Reservations
- 37 5.5 WAN Config
- 38 5.6 NAT Config
- 39 5.6.1 Static IP Setting (IP Forwarding)
- 39 5.6.2 Static Port Setting (Port Forwarding)
- 41 5.6.3 Filtering Setting
- 44 Chapter 6 Configuring Your Wide Area Network
- 44 6.1 Selecting the Right connection for your Broadband Internet Service
- 45 6.2 Setup on Compex SGX3226 for Broadband Internet Access
- 46 6.3 Configuring Static IP Connection
- 46 6.4 Configuring Dynamic IP Connection
- 47 6.4.1 How to configure Singapore Cable Vision (SCV) Service
- 47 6.4.2 How to Configure @HOME Cable Service
- 48 6.5 Configuring PPP over Ethernet Session (PPPoE)
- 48 6.5.1 How to Configure SingNet, PacNet &QALA DSL Broadband
- 51 Chapter 7 Advanced Configuration for Compex SGX3226
- 51 7.1 STP Config
- 51 7.1.1 STP Port
- 53 7.1.2 STP Bridge
- 55 7.2 IGMP Config
- 56 7.2.1 Definition on IGMP v1.0 and v2.0
- 57 7.3 Stack Configuration
- 59 7.3.1 Application on Stack Management
- 61 7.4 SNMP Configuration
- 62 7.5 RMON Statistics
- 63 7.6 Port Security
- 63 7.6.1 To delete MAC Address/es
- 64 7.7 MirrorPort Config
- 64 7.7.1 Using Mirror Port to monitor Traffic
- 65 7.8 Aging Control
- 66 7.9 Address Search
- 66 7.9.1 Host Search
- 67 7.9.2 MAC Address Search
- 68 Chapter 8 Using SYSTEM TOOLS Menu
- 68 8.1 Set System Clock
- 69 8.2 Remote Management
- 71 8.3 System Configuration
- 72 8.4 System Information
- 72 8.5 Change Password
- 73 8.5.1 Forget your password
- 74 8.6 Firmware Upgrade
- 75 8.7 Save or Reset Settings
- 75 8.7.1 Save
- 75 8.7.2 Backup
- 76 8.7.3 Restore
- 77 8.7.4 Clear and Reset
- 78 8.8 Message Window
- 78 8.9 Reboot Switch
- 79 8.10 Logout
- 80 Chapter 9 Using HELP Menu
- 80 9.1 Technical Support
- 81 Chapter 10 Application on Virtual LAN
- 81 10.1 Untagged and Tag Configuration using Web-based Interface
- 84 Appendix I Panel Views and Descriptions
- 89 Appendix II Technical Specifications