advertisement
Card
Printer
Solutions
General information
Getting started
Operation
Printing a card
Cleaning
Troubleshooting
Specifications
Appendix A
Appendix B
Appendix C
P320i Plastic Card Printer
A
PPENDIX A
Magnetic Card Stripe Encoder
This section contains information on the additional operations of the P320i
Printers with Magnetic Card Stripe Encoder. (See Chapter 2 for location.)
INTRODUCTION
Operation and maintenance requirements for the P320i Printer with the optional magnetic card stripe encoder.
(See Chapter 2 for location).
The magnetic encoder can be set for either high or low coercivity.
Card
Printer
Solutions
General information
Getting started
Operation
Printing a card
Cleaning
Troubleshooting
Specifications
Appendix A
Appendix B
Appendix C
P320i Plastic Card Printer
A - MEDIA LOADING ORIENTATION
The magnetic encoder is a factory installed item with the read/write head positioned below the card path, available with HICO
encoding (P320i CM1 or P320i CEM1) or LOCO
encoding (P320i CM2 or P320i CEM2).
When loading cards into the Card Cartridge, please ensure that the magnetic stripe is facing down and closest to the rear.
STRIPE
DOWN
Also available are Printer models with the
Magnetic Read/Write head positioned above
the card path, with HICO encoding (P320i CM3
or P320i CEM3) or LOCO encoding (P320i CM4
or P320i CEM4).
STRIPE
UP
When loading cards, please ensure that the magnetic stripe is facing up and closest to the rear.
NOTE
:
M1 = Stripe Down HICO
M2 = Stripe Down LOCO
M3 = Stripe up HICO
M4 = Stripe up LOCO
Approved HICO & LOCO PVC Cards are available. (See Appendix C).
ONLY USE cards that comply with ISO 7810 &
7811 standards for magnetic stripe cards. The magnetic stripe must be flush to the surface of the card to work properly. Never use taped-on magnetic stripes.
Card
Printer
Solutions
General information
Getting started
Operation
Printing a card
Cleaning
Troubleshooting
Specifications
Appendix A
Appendix B
Appendix C
P320i Plastic Card Printer
B - MAGNETIC ENCODER CLEANING
There exists two different processes to clean the Magnetic Stripe Encoder.
The first process consists of a standard cleaning of the printer. This cleans the most important parts of the printer; including the Print head, Transport
Roller and Magnetic Stripe Encoder (refer to chapter 4 "Cleaning" for more instructions).
The second process consists of a cleaning of the Magnetic Encoder using the Menu Button from the LCD Display.
To access the Magnetic Encoder Cleaning Menu prceed as below:
1. Leave power on.
2. Remove cards from the Card Feeder
3. Insert one Pre-Saturated Cleaning Card
(provided) through slot on the side of the Card
Cartridge.
4. Press the Menu button until the LCD screen shows CLEANING MENU.
5. Press the Select button to select.
6. Press the Menu button again until the LCD screen shows CLEAN MAG HEAD.
7. Run this operation by pressing the Select button.
ISO STANDARD ENCODING
Track # Field Separator
1 ^
2
3
=
=
Track density
210 BPI*
75 BPI*
210 BPI*
Valid Characters # of characters
79‡ Alphanumeric
(ASCII 20~95†)
Numeric
(ASCII 48~62)
40‡
Numeric
(ASCII 48~62) 107‡
* Bit per inch
† Except the ‘?’ character
‡ Including Start, Stop and LCR characters. Also note that tghese 3 characters are automatically managed by the magnetic encoder according to the ISO Standard
Norms.
NOTE: Refer to the Card Printer Programmer’s Manual for complete programming information.
advertisement
Related manuals
advertisement