Daily Procedures. CYBEX Eagle Calf

Cybex Eagle 11120 Standing Calf Owner’s Manual

4 - Assembly

TOOLS REQUIRED

•

•

•

•

•

•

•

•

7/32” Allen wrench

3/4” Allen wrench

9/16” Wrench

3/4” Socket or wrench

External snap ring pliers

Phillips screwdriver

Medium weight automotive engine oil

Torque Wrench

NOTE: Two people will be required for this procedure.

NOTE: It is the responsibility of the facility owner/owner of the equipment to ensure that there is appropriate clearance around each machine to allow for safe use and passage.

procedures listed on this instruction sheet.

2. Verify you have received the appropriate confi guration.

A. Verify that you received the correct color machine that you ordered.

B. Verify you received weight plates and weight plate decals.

C. Verify you received the Cybex Eagle Calf Raise Owner’s Manual.

D. Verify you received the warranty sheet.

3. Move to desired location.

A. Note the diminsions of the machine: idle - 58 L x 41 W x 58 H inches

147.32 L x 104.14 W x 147.32 H cm in use - 66 L x 41 W x 58 H inches

167.64 L x 104.14 W x 147.32 H cm

Machine Weight (with weight stack) - 740 lbs. (335.66 kg)

B. Determine if you can move your machine through the required doorway(s).

C. If the machine fi ts through the doorway(s), move machine to desired location and skip to step 5.

D. If weight stacks need to be installed proceed to step 6.

E. If the machine does not fi t through the door-way(s) then see step 4.

NOTE: If your machine fi ts through the doorway then skip step 4.

If your machine does not fi t through the doorway then perform step 4.

A. Carefully remove each (standard) cone-shaped shipping support using a 3/4” socket or wrench.

Assembly

Page 4-1