Set the Network Address. AUX EA Series

6 ArmorBlock 16-Point EtherNet/IP Module, Series A

Catalog Number Explanation

Refer to the table for a description of the catalog numbers.

Cat. No. Description Network

Connector

Auxiliary

Power

1732E-IB16M12

1732E-OB16M12

1732E-16CFGM12

1732E-IB16M12W

EtherNet 24V DC 16 Input

EtherNet 24V DC 16, 2 A Output

EtherNet 24V DC 16 Selectable

Points

EtherNet 24V DC 16 Input

WeldBlock Metal Housing

1732E-16CFGM12W EtherNet 24V DC 16 Selectable

Points

WeldBlock Metal Housing

Single D-Code M12

Single 4-pin mini

Single D-Code M12

Single 4-pin mini

Install the Module

Refer to the following sections to install your module.

•

Set the Network Address

•

Mount the Module

•

Connect the I/O, Network and Auxiliary Cables to the ArmorBlock

Module

Set the Network Address

The I/O block ships with the rotary switches set to 999 and DHCP-enabled.

To change the network address, you can do one of the following:

• adjust the switches on the front of the module.

• use a Dynamic Host Configuration Protocol (DHCP) server, such as

Rockwell Automation BootP/DHCP.

• retrieve the IP address from nonvolatile memory.

The I/O block reads the switches first to determine if the switches are set to a valid number. Set the network address by adjusting the 3 switches on the front

Publication 1732E-IN002B-EN-E - February 2011