advertisement
ArmorBlock 16-Point EtherNet/IP Module, Series A 15
Interpret the LED Indicators
This module has the following indicators:
• Network, Module, and Link status indicators for EtherNet/IP
• Auxiliary Power indicator
• Individual I/O status indicators for inputs and outputs.
Armor WeldBlock
Module status indicator
Link status indicator
EtherNet/IP
Network status indicator
MOD NET LINK
0 15
1
2
14
13
I/O status indicators 3
4
12
11
I/O status indicators
5
6
7
P
W
R
10
9
8
X10
X100 X1
Auxiliary power status indicator
44232
Publication 1732E-IN002B-EN-E - February 2011
16 ArmorBlock 16-Point EtherNet/IP Module, Series A
ArmorBlock
Link status indicator
Module status indicator
Network status indicator
I/O status indicators I/O status indicators
Auxiliary power status indicator
44231
Network Status Indicator – NET
State
Off
Flashing green
Green
Status Description
Not online The device is not initialized or the module does not have an IP address.
No CIP connections The device has no CIP connections.
The device has an IP address, but no CIP connections are established.
CIP connections The device is online, has an IP address, and CIP connections are established.
Recommended Action
Wait until the module has completed initialization or assign an IP address.
Establish a network connection.
None
Publication 1732E-IN002B-EN-E - February 2011
ArmorBlock 16-Point EtherNet/IP Module, Series A 17
State
Flashing red
Red
Flashing red/green
Status Description
Connection time out One or more connections have timed out.
Duplicate IP The module has detected that its IP address is already in use.
Self-test in progress
The module is performing a powerup self-test.
Recommended Action
Reset connections to the module.
Resolve the IP address conflict.
None
Module Status Indicator – MOD
State
Off
Flashing red/green
Green
Flashing red
Solid red
Status Description
Not powered There is no power applied to the device.
LED powerup test
The module is performing a powerup self-test.
Recommended Action
Apply power to the device.
None
Module operational
Minor fault
Critical fault
The module is operating normally.
The module has one of the following recoverable faults:
•
•
Firmware (NVS) update.
IP Address switches have changed.
The module has one of the following unrecoverable faults:
•
Self-test failure (checksum failure or ramtest failure at powerup).
•
Firmware fatal error.
None
•
Check your configuration and cycle power.
•
If a firmware update is in progress, wait for it to complete.
•
Verify that IP address switches are set to the desired value.
Cycle power to the module.
If that does not fix the fault, contact your Rockwell
Automation representative.
The module may need to be replaced.
Publication 1732E-IN002B-EN-E - February 2011
18 ArmorBlock 16-Point EtherNet/IP Module, Series A
IMPORTANT
The Module Status LED indicator remains solid red for a maximum of 30 s while the module completes its POST (Power-On Self Test).
Network Link Status Indicator – LINK
State
Off
Flashing green/off
Steady green
Status
No network link
Description
There is no network link established.
Network link active There is transmitting or receiving activity to the module.
Network link present There is a network link to the module.
Recommended Action
Establish a network link.
None
None
Auxiliary Status Indicator – PWR
State
Off
Green
Status Description
No auxiliary power There is no auxiliary power applied to the module.
Auxiliary power present
There is auxiliary power applied to the module.
Recommended Action
Apply auxiliary power to the module.
None
I/O Status Indicator – Individual Channels as Indicated by Numbers 0…15
State
Off
Yellow
Status
Output not energized or no valid input
Output energized or valid input
Description
Output is not energized or input is not valid.
Output is energized or input is valid.
Recommended Action
None
None
Publication 1732E-IN002B-EN-E - February 2011
ArmorBlock 16-Point EtherNet/IP Module, Series A 19
Specifications
ArmorBlock 2-Port EtherNet/IP Module – 1732E-IB16M12x,
1732E-16CFGM12x
Attributes
Number of inputs
Input type
Voltage, off-state input, max
Voltage, on-state input, max
Voltage, on-state input, nom
Voltage, on-state input, min
Voltage, sensor source, max
Voltage, sensor source, min
Current, off-state input, max
Current, on-state input, max
Input delay time - ON to OFF and OFF to ON
Value
16
Sink, 24V DC
5V DC
30V DC
24V DC
11V DC
30V
11V
1.5 mA @ 5V DC
5 mA @ 30V DC
0…16000
μ s
ArmorBlock 2-Port EtherNet/IP Module – 1732E-16CFGM12x,
1732E-OB16M12
Attribute
Number of outputs
Output type
Voltage drop, on-state output, max
Voltage off-peak blocking, min
Voltage, on-state output, max
Voltage, on-state output, min
Voltage, on-state output, nom
Voltage, sensor source, max
Value
16
Source, 24V DC
0.5V DC
30V DC
30V DC
11V DC
24V DC
30V
Publication 1732E-IN002B-EN-E - February 2011
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project