7.5 Setting the Day Change (Hour and Minute). Acroprint ATR120r Time Clock, ATR120

7.5 Setting the Day Change (Hour and Minute)

Note: this feature can be used for employees that start their shift on the previous day and end on the next day

Press Enter to edit program Code 05.

Press + or – to edit the hour.

Press Enter to set the Day Change Hour.

Press + or – to edit the minute.

Press Enter to set the Day Change Minute.

7.6 Set Vertical Printing Position (Up/Down)

Code Hour

Code Minute

Press Enter to edit program code 07.

Press + or – to edit the printing position (0-9).

Code

Press Enter to set the printing position.

Note: Increasing the value from 00 to 09 moves print up a total of 6mm. Decreasing the value moves the print down. “5” is the Factory Default.

7.7 Setting the Keyboard Beep

Press Enter to edit program code 08.

Press + or – to set the keyboard beep:

00 01 = Beep On (Factory Default)

00 02 = Beep Off

Press Enter to set the keyboard beep.

Code

7.8 Setting the Menu Password

Note: the menu password prevents unauthorized personnel from accessing the clock menus.

Press Enter to edit program code 09.

Press + or – to edit the password.

Note: 00 00 is the Factory Default (no password).

To remove a password simply change the password back to 00 00.

Press Enter to set the password.

Code

Press Mode to advance to the next programming mode (B001). To exit programming mode slide the switch on the back of the clock to “Run”.

- 13 -