advertisement
SERVICE MANUAL AVALON La Petite-X Single-Cup Brewer
Brewer Funnel
8.6.3 Coffee Brewer
Rinsing the Brew Chamber:
Frequency: Weekly or every 200 cycles
1. Place a large cup or other suitable container below the
dispensing nozzle to catch the HOT rinse water;
2. Toggle the ingredient switch to Off (SW5 see main board);
3. Order several coffees for the hot water to flow through the
system;
4. Toggle the ingredient switch back ON;
5. Remove the hose and remove the brew chamber’s
funnel to dislodge coffee residue trapped underneath it
and rinse it out;
6. Replace it and align the opening with the brown water
hose so that it is against the wall to form a circular water
motion around the funnel;
7. Order a large coffee to confirm that all parts have been
replaced correctly.
Brewer Chamber
Hose Support
Brew Chamber
Brewer Funnel
Frequency: As needed or weekly
If there are coffee grounds accumulated, remove the assembly for manual cleaning under hot water:
1. Remove the brown water hose;
2. Lift off the funnel and pull out of the brew chamber;
3. Rinse thoroughly under hot water;
4. Air dry completely;
5. Reinstall all parts in the reverse order.
6. Order a large coffee to confirm that all parts have been replaced correctly.
Brewer Assembly Cleaning
Frequency: Monthly or every 1,000 cycles
In order to maintain optimal performance of the brewer assembly, we recommend that it be removed from the unit and cleaned / rinsed with hot water.
(see page 61 for instructions on removing the brewer)
1. Rinse thoroughly under hot water to remove visible soil;
2. Lift off the funnel and pull out of the brew chamber;
3. Rinse thoroughly under hot water;
4. Air dry completely;
5. Reinstall all parts in the reverse order.
6. Order a large coffee to confirm that all parts have been replaced correctly.
The Petite-X Revision B 03/2010 51
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 17 4.8.1 Main Board (PCB) Descriptions
- 23 6.1.1 Clearances
- 25 6.4.1 Tank Lid Preparation
- 26 6.4.2 Adjusting the Tank Overflow Float
- 26 6.5.1 Install the 3 Beans Canister
- 27 6.5.2 Lock the 3 Bean canister
- 27 6.5.3 Install the Plastic Top fitting part
- 27 6.5.4 Install the Plastic Top
- 36 7.1.1 Dictionnary
- 46 8.3 Cleaning and Sanitizing Schedule
- 47 8.5.1 Cleaning the drip tray
- 48 8.5.2 Emptying the waste bin
- 49 8.6.1 Coffee Canisters
- 50 8.6.2 Soluble Canisters
- 51 8.6.3 Coffee Brewer
- 52 8.6.4 Fan
- 53 8.6.5 Stainless coffee chute
- 54 8.6.6 Plastic chute of the 3 bean canister
- 60 10.2.1 Storing the Brewer Assembly
- 64 11.1 “Error” Appearing on the LCD Screen