advertisement
SAFETY PRECAUTIONS
Please read these warnings before operating or servicing machine.
CAUTION: This machine emits hot steam. To prevent burns, avoid contact with hot steam. Before service machine, close steam supply valve and purge lines.
CAUTION: Shut off electrical supply before servicing to avoid electrical shock.
OPERATING INSTRUCTIONS
1. Machine can be operated from any side. Position foot switches at convenient location.
2. Place garment on form. Adjust shoulder form width by turning knob in either direction. The Mr.
Cissell form requires adjustment of the Waist, Hip and Lower control knobs. After adjusting lock the controls by twisting the knobs clockwise.
3. Press the AIR foot switch to operate the blower for sizing the form bag. Size the bag by adjusting the DAMPER CONTROL. Using the Control Panel, press the MODE SELECT until the AIR light glows and press START/CANCEL to operate the blower, then proceed with sizing the bag.
4. Set the three control timers to the recommended settings:
Steaming: 6-9 seconds
Conditioning: 4-9 seconds
Drying: 12-16 seconds
These settings should be fine-tuned to the particular garment, steam pressure and ambient conditions. The recommended cycle is the steam/air conditioning and the drying. The control will power up in this cycle.
5. This machine has the ability to pre-steam a garment prior to the automatic finishing cycle. To actuate this cycle, press the MODE SELECT pad until the PRE-STEAM LIGHT glows, then press
START. Using the foot switch, press PRE-STEAM.
6. If a cycle is operating, it can be cancelled at any time by pressing any foot switch or control panel pads.
Control Panel
Page 5
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 2 Cissell Equipment Warranty
- 4 Specifications and Dimensions
- 5 Installation Instructions
- 6 Operation and Safety Precautions
- 7 Operation-Controls
- 8 Service Chart and Maintenance
- 9 Revolving Form Adjustment
- 10 Instructions for Removing and Replacing Bag
- 11 Instructions for Tying Lower Tie String
- 12 Replacement Form Bags
- 13 Instructions for Adjsting Height of Revolving Form
- 14 Mr. Cissell Form Assembly Parts
- 16 Waist, Hip, and Lower Control Parts
- 17 Base and Blower Parts
- 18 Ms. Cissell and Sensi Form Parts
- 20 Suzie II Parts
- 21 Front and Rear Paddle Assembly
- 22 Steam Column and Piping Parts
- 23 Condenser and Spray Gun Parts
- 25 Damper Assembly Parts
- 26 Control Panel and Electrical Parts
- 27 Wiring Diagrams