Installation. Magellan RoadMate 360 - Automotive GPS Receiver, P-110, RoadMate 360


Add to my manuals
95 Pages

advertisement

Installation. Magellan RoadMate 360 - Automotive GPS Receiver, P-110, RoadMate 360 | Manualzz

Installation

Installation

Installation

Take care when mounting the Magellan RoadMate in your vehicle, whether using the windshield mount or another mount, that it does not obstruct the driver’s view of the road. Make sure that the placement of the Magellan

RoadMate and cable does not interfere with the operation of vehicle safety devices, such as air bags. You assume the risks associated with damage to your vehicle or your vehicle’s occupants as a result of how you choose to mount the Magellan RoadMate.

Installing the Windshield Mount

Slide the mount assembly onto the windshield mount bracket attached to the back of the unit.

Press the windshield mount to the glass and rotate the locking lever toward the glass until it locks into place.

Plug the power cable into the unit.

Plug the cigarette lighter connector into an appropriate 12V receptacle in your car.

7

Rotate the antenna upward.

Installation

Installation is complete. You are ready to turn the Magellan RoadMate on and go.

Installing the External Antenna

The external antenna (not included) provides faster satellite fix times and greater signal strength. Because it is mounted outside of the vehicle, it is not affected by reflective coatings on windows and has an unobstructed line of sight to the satellites.

Remove the standard antenna by rotating it completely upward.

Hold the antenna at the pivot point and pull straight off the back of the unit.

Attach the antenna to a flat, horizontal portion of the roof of your vehicle. The antenna is magnetic. Do not use any adhesives to attach the antenna to your vehicle.

8

Installation

Route the antenna cable along the weatherstripping of the door and through the vehicle interior so it such a way that it does not interfere with the operation of the vehicle.

Plug the end of the external antenna into the socket on the back of the unit.

Replace the unit onto the mount in your vehicle. There is no special settings to make to the unit in order to use the external antenna. Turn the unit on and operate normally.

9

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement

Table of contents