Replacing the batteries. Alpine N852A - NVE, NVE-N852ADVD

Remote control (RUE-4136)

Tips a Avoid dropping this remote control or placing it in pants pockets. Doing so may cause damage to the case or buttons, shorten battery life or cause the system to malfunction.

a To clean this device, wipe it with a dry cloth. (If it is extremely dirty, wipe it with a wrung damp cloth.) Never use benzene, paint thinner or harsh chemicals which can cause deterioration of the case or paint.

a Do not expose this remote control to direct sunlight (i.e. on the dashboard) for extended periods of time.

Replacing the batteries

Use two AAA-type batteries.

1 Open the cover

Opening the battery cover.

Push on the cover and slide it as indicated by the arrows then the cover will be removed.

2 Replace the batteries

Replacing the battery.

Remove the old batteries. Insert new ones matching the (+) and (–) polarities as shown in the diagram inside the remote control.

3 Close the cover

Closing the cover.

Push the cover in the arrow direction until a click is heard.

Remote Control Holder Installation

• If direct sunlight reaches the remote control mounted on the holder, remove the remote control from the holder and put it in the glove compartment.

• If double-sided adhesive tape cannot install the holder securely, use screws.

Note: Attach the blue protective paper side of double-sided tape onto the console box, etc.

Remote Control

Holder

Double-Sided

Adhesive Tape

(Before attaching the tape, make sure the mounting location is free from dust or dirt.)

Protective Paper

Remote

Control

Reinforcing Screws

Console Box etc.

13