In case of difficulty. Alpine N852A - NVE, NVE-N852ADVD

16

Reference

In case of difficulty

If you encounter a problem, please review the items in the following checklist. This guide will help you isolate the problem if the unit is at fault. Otherwise, make sure the rest of your system is properly connected or consult your authorized Alpine dealer.

Symptom

No operation/

No display

Cause

Blown fuse

Ambient temperature over

122°F (50°C)

Moisture condensation

Solution

Replace with a fuse of the same rating.

Lower the temperature in the vehicle below 122°F (50°C) by driving with the windows open or air conditioner on.

Allow enough time for condensation to evaporate (about 1 hour, depending on ambient temperature and humidity).

Drive the vehicle in an area of good GPS reception to allow the unit to recalibrate itself.

The present vehicle position cannot be measured correctly.

The vehicle position changed after the ignition was switched off.

• Movement on a ferry boat

• Rotation of a parking lot turntable

• Movement by tow truck

Poor satellite configuration Vehicle position is displayed incorrectly on the screen

Screen not displayed

Measurement is 2 dimensional

The navigation monitor is turned off.

"CANNOT READ

DISC" is displayed for a certain operation.

The disc is dirty.

The pickup lens is dirty.

Unstable operation

The remote control batteries are wearing out.

Move to a location where GPS satellite reception is easy.

Press the ON button on the remote control.

Clean the disc.

Have the pickup lens cleaned periodically.

Replace the remote control batteries.