Step 7 Design a Faceplate Overlay. Watlow MINICHEF Deep Fat Fryer, MINICHEF 2000
Add to My manuals111 Pages
advertisement
▼
Scroll to page 2
of
111
Step 7 Design a Faceplate Overlay
To complete the installation, you must apply a graphic membrane to the front panel of the controller. The following artwork will help you design and create a membrane for this application. For more dimensions and guidelines, see the Hardware & Software
Setup Guide.
Suggested End-user Overlay:
Your Company Logo
A p p l i c a t i o n 1 3
Heat
Menu
1
Menu
2
Menu
4
Menu
5
Menu
3
Menu
6
This Prototyping and Training Membrane Overlay will help you with the configuration and programming steps. To order it, see the Ordering Information at the back of this guide.
M INI C HEF 2000
A
D
Edit
Home
G
B
E
Enter
Escape
H
C
F
Wa t l o w M
I N I
C
H E F
2 0 0 0 ■ 3 9
advertisement
Related manuals
advertisement
Table of contents
- 3 Automatic Deepfat Fryer with Autolift Control
- 25 Manual Deepfat Fryer with Autolift Control
- 37 Pressurized Automatic Deepfat Fryer
- 57 Pressurized Manual Deepfat Fryer
- 67 Automatic Deepfat Fryer
- 97 Manual Deepfat Fryer
- 108 Ordering Information
- 37 Introduction to Application
- 39 Configuration Mode Quick Reference
- 40 Program Mode Quick Reference
- 41 Step 7 Design a Faceplate Overlay
- 42 Step 8 Operate the Controller
- 62 Introduction to Application
- 64 Configuration Mode Quick Reference
- 65 Program Mode Quick Reference
- 66 Step 7 Design a Faceplate Overlay
- 67 Step 8 Operate the Controller
- 67 Introduction to Application
- 69 Configuration Mode Quick Reference
- 70 Program Mode Quick Reference
- 71 Step 7 Design a Faceplate Overlay
- 72 Step 8 Operate the Controller