Assembly. Craftsman 113213213, 113.213213

MEDIUM

SCREWDRIVER

assembUy

COMBINATION SQUARE MUST BE TRUE.

Check its accuracy as illustrated below.

WARNING: For your own safety, never connect

[ plug to power source outlet until all assembly

_ steps are completed.

TOOLS NEEDED

COMBINATION

DRAW LIGHT

LiNE OH BOARD

ALONG

STRAIGHT EDGE OF

BOARD 3/4" THICK-

THIS EDGE MUST BE

PERFECTLY STRAIGHT

F

SQUARE

8-INCH ADJUSTABLE

WRENCH

SHOULD BE OVERLAP WHEN

SQUARE IF FLAPPED OVER IN DOTTED POSITION

ASSEMBLY OF BASE/COLUMN

1. Positionbase on floor.

2_ Remove protective sleeve from column tube and discard. Place column assembly on base, and align holes in column support with holes in base.

3. Locate four (4) 12mm Dia. x 40mm long bolts among loose parts bag.

4. Install a bolt in each hole through column support and base and tighten with adjustable wrench.

!

i

COLUMN

SUPPORT

12rnm DIA:X 40turn LONG BOLT

ASSEMBLY OF ELEVATION WORM GEAR AND TABLE CRANK

1. Find elevation worm gear shaft, the crank handle and table crank in the loose parts bag. Insert the elevation shaft into the table support and extend the shaft through the opening as far as possible. The crank is to be installed on the elevation worm gear shaft, the set screw is to be aligned with the fiat portion of the shaft. The crank is to be positioned as close to the arm support as possible, then tighten set screw with a 3mm HEX "L" wrench. See illustration.

2. Screw the crank handle into the table crank as illustrated. Use an adjustable wrench to tighten the crank handle securely.

._

10

TABLE SUPPORT

ASSEMBLY

TABLE