Installing Light Bulb. Craftsman 113213213, 113.213213

iNSTALLiNG UGHT BULB

1. install a light bulb (not larger than 60 watt) into the socket insidethe head.

BEVEL SCALE

NOTE: The bevel scale has been included to provide a | quick method for beveling the table to approximate ZE

.ol

angles. If precise accuracy is necessary, a square, or UNE_ other precision measuring tool should be used to position the table.

1. To use the bevel scale do the following.

a. Using an adjustable wrench, turn the nut (on the table lock pin) clockwise. This will pull the table lock pin out of its indexing hole in the table support.

b. Lcosen the table bevel lock by turning it counterclockwise using an adjustable wrench.

c. Move table so desired angle on bevel scale is straight across from zero line on table support, d. Retighten the table bevel lock,

2. To return the table to the 90° position do the following: a. Loosen the table bevel lock, b. Move the table and reinstall the table lock pin into the indexing hole in the table support, Tap in gently into place.

c. Tighten the table bevel lock, d. Tighten the nut (on the table lock pin) finger tight so it won't vibrate loose.

BEVEL SCALE

LOCK

PIN

TABLE SUPPORT

TABLE

BEVEL

LOCK

TABLE

18