advertisement
Troubleshooting guide
Below is a table describing simple measures that can help you eliminate most problems likely to emerge when this unit is in use. If below measures do not help, turn to a service center or to the nearest dealer.
Symptom
No power
Cause
The car ignition is not on.
Solution
If the power supply is properly connected to the car accessory switch the ignition key to “ACC”.
No sound
The fuse is blown.
Volume is on minimum.
Wiring is not properly connected.
Replace the fuse.
Adjust volume to a desired level.
Bad sound quality
The installation angle is more than 30 degrees.
The disc is extremely dirty or defective.
Check wiring connection.
Adjust the installation angle to less than 30 degrees.
Disc cannot be The unit already contains a disc.
loaded or ejected Moisture condensation.
Disc cannot be read
The disc is inserted upside down.
Clean the compact disc/try to play a new one.
Remove the disc in the player then put a new one.
Leave the unit idle for an hour, then retry.
Insert the compact disc with the label side facing upward.
Compact disc is extremely dirty or defective. Clean the disc or try to play a new one.
Buttons do not work
Temperature inside the car is too high.
Cool off until the ambient temperature returns to normal.
Reset the unit with the help of RESET button.
The built-in microcomputer is not operating properly.
Front panel is not properly fix into its place. Install the front panel properly.
The antenna cable is not connected.
Insert the antenna cable properly.
The radio does not work
The radio station automatic tuning does not work
The signals are too weak.
Select stations manually.
32
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project