3.13.15.3 Delete Label (LightScribe models with hard drive only). Kanguru BR-DUPE-S1

Delete Label

3.13.15.3 Delete Label (LightScribe models with hard drive only)

The Delete Label function will allow you to delete an existing LightScribe Label saved in the hard drive.

Print Setup

3. Delete Label

1. From the Print Setup menu, press the UP or DOWN button to navigate to Delete Label. Press the ENT button to enter the Delete Label menu.

Please Select Label

[LSlabel.lsi] 7M

Label File Not Found!

Press ENT to continue.

Delete Partition

[LSlabel.lsi], OK?

[LSlabel.lsi]

Deleted!

2. The Select Label screen appears. Press the UP or

DOWN button to select a .lsi file and then press the ENT button to confirm your selection.

Note: If the hard drive does not conatain any LightScrive label files, you will see the “Label File Not Found” screen. Press the ENT button to continue and then see section 3.13.15.1 Load Label (LightScribe models with

hard drive only), p.51 for more information on loading lable files.

3. The Delete Partition screen appears. Press the ENT button to proceed with deleting the partition.

4. Once the Delete process has completed you will see the

Deleted screen. After a few seconds you are returned to the Print Setup menu.

53