Connecting to Video Devices. JVC DLA-G150CLE, DLA-G150CLU

r

DIGITAL ZOOM T/W buttons

A part of image can be magnified up to four times on the screen.

Each time the T or W button is pressed, the image is enlarged or the enlarged image is reduced by a certain degree. (Refer to page 37.)

* Images which are enlarged with the digital zoom become less clear.

* Depending on the video signal source (UXGA, etc.), this button does not work.

t

PC buttons

Use these buttons to select a device connected to the PC

1, PC 2 or DVI terminals. (Refer to page 33.)

* “PC 1”, “PC 2” or “DVI” will be displayed on the top right of the projected image. (This function can be disabled using the menu.) y

SCREEN W/S buttons

Changes the projection screen size to [4:3] or [16:9].

u QUICK ALIGN. (Quick Alignment) button

Use this button to automatically align “Horizontal and vertical position”, “Tracking” and “Phase” for the projected image.

During the automatic alignment, “Quick Alignment” appears on the screen, and disappears after alignment is finished. (Refer to page 36.)

* The “Quick Alignment” function only works when the signal is input from the input terminal of PC 1, PC 2 or

DVI. It does not work when the signal is input from the

VIDEO IN terminal (VIDEO, Y/C and COMP. input terminal).

CAUTION

• Automatic alignment with the quick alignment function should be carried out on a bright still-picture. This function may not work correctly on a dark picture or motion-picture.

If adjustment with this function is not satisfactory, adjust

“Horizontal and vertical position”, “Tracking” and “Phase” in the menu mode.

Controls and Features Controls and Features

Installing Batteries

Install batteries in the remote control. If the remote control has started to work erratically, replace the batteries.

1 Open the back cover.

Open the back cover in the direction of the arrow.

2

3

Install the batteries.

Place the two supplied batteries (AA/R6-size) in the remote control as illustrated below.

Close the back cover.

First fit the claws on the back cover in the case, then close the back cover in the direction of the arrow.

Precautions for using batteries

If batteries are used incorrectly, they may crack or leak liquid. This could cause a fire, burn, malfunction, or staining or damaging of the surroundings.

Beware of the following:

• Do not mix new and old batteries.

• Do not mix different types of batteries as they differ in characteristics.

• Place batteries so they match the polarities indicated:

(+) to (+) and (–) to (–).

• Be sure to put the minus (–) end in first to avoid short-circulating.

• Use only designated batteries.

• Remove the batteries if the remote is not to be used for a prolonged period.

• When the batteries are exhausted, replace them immediately. Otherwise, liquid could leak, or malfunction could occur due to leaking liquid. If the leaked liquid contacts the skin, wipe it off with a cloth, otherwise the skin could become rough.

• Do not put batteries into a fire or try to recharge them.

• Batteries run for six months to one year in normal use.

However, the batteries supplied are for confirming operation and may not run that long. When the remote control starts failing to work properly, replace the batteries with new ones.

This instruction below applies only to the use in Holland.

Gebruike batterijen:

13 14