GENERAL. Kenwood TK-3202, TK-3206

2

TK-3202/3206

GENERAL / SYSTEM SET-UP

INTRODUCTION

SCOPE OF THIS MANUAL

This manual is intended for use by experienced technicians f a m i l i a r w i t h s i m i l a r t y p e s o f c o m m e r c i a l g r a d e communications equipment. It contains all required service information for the equipment and is current as of the publication date. Changes which may occur after publication are covered by either Service Bulletins or Manual Revisions.

These are issued as required.

ORDERING REPLACEMENT PARTS

When ordering replacement parts or equipment information, the full part identification number should be included. This applies to all parts, components, kits, or chassis. If the part number is not known, include the chassis or kit number of which it is a part, and a sufficient description of the required component for proper identification.

PERSONAL SAFETY

The following precautions are recommended for personal safety:

● DO NOT transmit until all RF connectors are verified secure and any open connectors are properly terminated.

●

●

SHUT OFF and DO NOT operate this equipment near electrical blasting caps or in an explosive atmosphere.

This equipment should be serviced by a qualified technician only.

SERVICE

This radio is designed for easy servicing. Refer to the schematic diagrams, printed circuit board views, and alignment procedures contained within.

Unit

Model

& destination

TK-3202 K,M

TK-3206 M

TX-RX Unit Frequency range

X57-6890-20 450~490MHz

TK-3206 M3 X57-6890-22 400~430MHz

Remarks

IF1 : 38.85MHz

LOC : 38.4MHz

TK-3202

K2,

M2

X57-6890-23 470~512MHz

SYSTEM SET-UP

Merchandise received

License and frequency allocated by FCC

Choose the type of transceiver

Transceiver programming

Are you using the optional antenna?

NO

Frequency range (MHz)

TX/RX 450~490

TX/RX 400~430

TX/RX 470~512

RF power

4.0W

4.0W

4.0W

Type

TK-3202 (K,M)

TK-3206 (M)

TK-3206 (M3)

TK-3202 (K2,M2)

A personal computer (IBM PC or compatible), programming interface (KPG-22), and programming software (KPG-87D) are required for programming.

(The frequency, TX power HI/LOW, and signalling data are programmed for the transceiver.)

YES

KRA-23 or KRA-27

Optional antenna

Are you using the speaker microphone?

NO

YES

KMC-17 or KMC-21

Speaker microphone

(Option)

Delivery