PC Mode Adjustments
Auto adjustment
- Automatically adjusts picture position and minimizes image shaking.
READY
Press the menu button and then use the up/down button to select SPECIAL menu.
Press the vol ( G ) button.
menu up down vol
1
Use the up/down button to select SCREEN and then press the vol ( G ) button.
up vol down
SPECIAL
LANGUAGE
ARC
TRANSPARENCY
PIP/DW
SET ID
COLOR TEMP.
G
G
G
G
G
G
G
G TO SET
2
Use the up/down button to select
AUTO.CONFIG.
( G ) button.
and then press the vol
AUTO.CONFIG.
G
SCREEN
RGB-OUTPUT
RESET
G
G
G
G
TO SET
G
G
G
G up vol down
• When AUTO.CONFIG.
has finished, " OK " will be shown on screen.
• If the position of the image is incorrect, try Auto adjustment again.
3 If picture needs to be adjusted more after Auto adjustment, you can manually adjust the image position and PHASE .
Tip
• If the image is still not correct, your Monitor is functioning properly but needs further adjustment.
23
24
PC Mode Adjustments
Adjusting horizontal / vertical position manually
- Only adjust V-POSITION and H-POSITION in DTV or component 480p/720p/1080i.
READY
Press the menu button and then use the up/down button to select SPECIAL menu.
Press the vol ( G ) button.
menu up vol down
1
Use the up/down button to select SCREEN and then press the vol ( G ) button.
up vol down
2
Use the up/down button to select V-POSI-
TION or H-POSITION and then press the vol
( G ) button.
up vol down
SPECIAL
LANGUAGE
ARC
TRANSPARENCY
PIP/DW
SET ID
COLOR TEMP.
G
G
G
G
G
G
G G TO SET
LANGUAGE G
V-POSITION G
SCREEN
RGB-OUTPUT
RESET
G
G
G
G
G
G
G
G
0
3
Press the vol button to adjust until you get desired horizontal or vertical position and then press the enter button to remove menus.
• The adjustment range of V-POSITION is -50 ~ +50.
• The adjustment range of H-POSITION is -100 ~ +100.
• Based on the input mode, the adjustment range of V-POSITION/H-POSITION may change.
• Based on the input signal, the position of the picture may not change even though you have adjusted the horizontal or vertical position with this function.
vol vol enter
Picture Phase Adjustments
• If the picture isn’t clear after auto adjustment and especially if the characters are still trembling, then adjust the picture phase manually.
• When watching PIP/TWIN PICTURE, the SCREEN menu option is not available.
READY
Press the menu button and then use the up/down button to select SPECIAL menu.
Press the vol ( G ) button.
menu up down vol
1
Use the up/down button to select SCREEN and then press the vol ( G ) button.
up vol down
2
Use the up/down button to select PHASE and then press the vol ( G ) button.
up vol down
SPECIAL
LANGUAGE
ARC
TRANSPARENCY
PIP/DW
SET ID
COLOR TEMP.
G
G
G
G
G
G
G
G TO SET
LANGUAGE G
G
RESET
G
G
G
G
G
G
G
G
30
3
Use the vol button to adjust phase and then press the enter button.
• The adjustment range of PHASE is 0 ~ 63.
vol vol enter
Initializing (Reset to factory value)
• To initialize the adjusted value, select RESET with the up/down button and then press the vol ( G ) button.
25