Suzuki Engine Interface Configuration. Lowrance electronic LMS-525C DF, LMS-520C

Suzuki Engine Interface Configuration

To input Device Name:

1. Press MENU| MENU , use ↑ ↓ to select NMEA 2000 and press ENT . The

NMEA 2000 menu will appear with five options: Bus Setup, Fuel Management, NMEA 2000 Alarms, Waypoint Sharing and Backlight Synchronization.

2. Highlight B

US

S

ETUP

and press ENT , which will open the Bus Configuration menu. A list of network devices will be at the top of the page.

3. Use ↑ ↓ to select the engine interface you want to rename and press

ENT . The Device Configuration menu will appear with the Device Name dialog box highlighted.

4. Press ENT and use ↑ ↓, ← → to input a name for the interface. Press

ENT . Press EXIT repeatedly to return to the main display.

To select a Location:

1. Press MENU| MENU , use ↑ ↓ to select NMEA 2000 and press ENT . The

NMEA 2000 menu will appear with five options: Bus Setup, Fuel Management, NMEA 2000 Alarms, Waypoint Sharing and Backlight Synchronization.

2. Highlight B

US

S

ETUP

and press ENT , which will open the Bus Configuration menu. A list of network devices will be at the top of the page.

3. Select the desired engine interface and press ENT . The Device Configuration menu will appear.

4. Highlight L OCATION

and press ENT , which will open the Location menu with the following options: Port, Center, Starboard and Unknown.

5. Select the desired location and press ENT . The following confirmation message will appear: Are you sure you wish to change this device's con- figuration?

6. Press ENT . Press EXIT repeatedly to get back to the main display.

To select Engine Type:

1. Press MENU| MENU , use ↑ ↓ to select NMEA 2000 and press ENT . The

NMEA 2000 menu will appear with five options: Bus Setup, Fuel Management, NMEA 2000 Alarms, Waypoint Sharing and Backlight Synchronization.

2. Highlight B

US

S

ETUP

and press ENT , which will open the Bus Configuration menu. A list of network devices will be at the top of the page.

3. Use ↑ ↓ to select the desired engine interface and press ENT . The Device Configuration menu will appear.

4. Highlight E

NGINE

T

YPE

and press ENT , which will open the Engine

Type menu with the following options: DF40, DF50, DF60, DF70,

DF90/115, DF140, DF150, DF175, DF200/225, DF250 and DF300.

221