Maintenance. RIDGID Aspiradora para líquidos y sólidos sin cable de 18 V, WD0318, 18V Cordless Wet/Dry Vac, Aspirateur sec/humide sans fil 18 V, X4 18-Volt Cordless Wet/Dry Vacuum


Add to My manuals
44 Pages

advertisement

Maintenance. RIDGID Aspiradora para líquidos y sólidos sin cable de 18 V, WD0318, 18V Cordless Wet/Dry Vac, Aspirateur sec/humide sans fil 18 V, X4 18-Volt Cordless Wet/Dry Vacuum | Manualzz

SP6920 ESF 3 gallon.qxp_SP6585 WD4050EX 5/13/14 4:54 PM Page 11

Maintenance

Filter Removal

1. Grasp the drum latches on both the right and left side of the power head.

Slowly pull the drum latches out and up from the drum. Lift the power head off the drum. Place the lid assembly to the side.

2. To remove the filter for cleaning or replacement, unscrew the filter nut from the filter cage. Hold the filter tabs of the filter in each hand.

3. With one thumb on the threaded screw, which protrudes through the integrated filter plate, lift up on the filter tabs while pushing down on the screw.

4. This action will cause the filter to release from the filter cage. Slide filter off cage.

!

WARNING: Do not remove the filter cage and float. The float prevents water from entering the impeller and damaging the motor.

The cage prevents fingers from touching the moving impeller.

Filter Installation

1. Carefully slide the filter over the filter cage and press down on the outside edge of the filter until the rubber gasket on the bottom of the filter seats securely around the base of the filter cage and against the lid.

2. Align the small center hole in the top of the filter over the threaded stud on the filter cage allowing it to protrude through.

NOTE: The filter will take the shape of the oval filter cage when in place.

3. Place filter nut onto threaded screw and tighten it down. Finger tighten only.

NOTE: Lever of filter nut should be away from filter cap as shown.

IMPORTANT: Do not overtighten as this may deform or crack the filter cage or filter.

11

4. To assemble the power head to the drum, position power head over drum, with drum latches lined up with recess in drum. (The power head will only fit on the drum one way).

5. Position bottom of the latch in drum recess. Push top of latch towards power head to lock.

6. Your Vac is now ready to use.

advertisement

Related manuals

advertisement

Table of contents