Install Leveling Legs. Gladiator GAJG36GRESG, GAJG36GRDG, GAJG36FDZW, GALG36KDESG

P1

EEE

DDD

CCC

BBB

AAA

P2

P1

1.

Place a shelf (P5mr) so that the 2 tabs in the shelf ends are aligned with the pair of slots in the middle of the cabinet sides.

P2

P1

P5mr

P1

P3

P3

Install Leveling Legs

(optional)

IMPORTANT: If you are going to install the cabinet on Gladiator

GearWall ® panels or GearTrack ® channels, you do not need to install leveling legs.

1.

Place the cabinet on its side.

2.

Screw a leveling leg (P4) into each of the four rivet nuts located at the corners of the cabinet as shown.

2.

Tilt the shelf so that one end is higher than the other as shown.

P1

EEE

P3

P4

A

A

B

A. Push down.

B. Lift up.

3.

Insert the shelf into the cabinet so that the higher end is directly above the desired slots and push the shelf down into place behind the side slots. Raise the lower end so it is directly above the desired slots and push the shelf down.

NOTE: You may need to slightly bend the shelf tabs outward for the tabs to engage in the slots. Make sure the shelf tabs are in place behind all the slots, as shown.

A. Leveling legs

3.

Stand the cabinet upright.

4.

If you have not already done so, fasten the two bolts at each front corner, of the cabinet frame. Completely tighten all of the cabinet bolts and nuts.

Install Shelves

IMPORTANT:

■ The shelves are supported by the metal slots on the cabinet sides.

■ Make sure the magnet in the right of each long shelf edge is facing out.

A. Cabinet slot

B. Shelf tab

A

B

5